Panasonic PV-DV702-K Operating Instructions Manual page 46

Editing Features
Copying your Tapes to
S-VHS or VHS Cassette
A/V Cable
(Supplied)
To Audio In
Source (Playing) Palmcorder
DC Cable
(Supplied)
A/V Cable
(Supplied)
S-Video
Cable (not
supplied)
To Audio In
To S-Video In
(If there is S-Video In)
S-VHS Mode Only
Monitor with your TV
• Turn the TV ON and select its VCR
channel (either CH3 or CH4).
• Set the VCR/TV Selector on the
recording VCR to VCR.
46
DV702-K.p 44-47.p65
Before you begin
• Connect both Palmcorder and VCR to
their power sources.
• Connect the Palmcorder to a VCR as
illustrated left.
• Turn ON both units.
A/V OUT
• Set the recording VCR's Input Signal
Selector to LINE.
• Set the Palmcorder POWER to VCR.
Back of TV
• Before using S-VIDEO Connector,
insert the DC Cable into the DC IN
Audio In Video In
Terminal. (p. 15)
1
To
Insert a pre-recorded tape
Video In
into the source (playing) Palmcorder
and a blank tape, with record tab in
place, into the target VCR (Recorder).
2
Press
S-VIDEO OUT
When the tape reaches the point from
A/V OUT
which you want to start dubbing, press
PAUSE.
3
TV
Place the VCR into REC/PAUSE
(To View)
mode. (See VCR manual.)
4
Simultaneously, press PAUSE on
VHF Connecting
both units to begin copying.
Cable (not
supplied)
5
Recording:
Press STOP on both units when
VCR (Rear)
copying is completed.
Note
Audio In
• For technical reasons, dubbing a tape
may reduce its quality.
• Press DISPLAY ON TV on the
Palmcorder Remote Control to eliminate
EVF/LCD Monitor indications.
• If the Time Code is displayed in the EVF
or LCD monitor, it cannot be reset.
S-Video In
• Only the DATE/TIME, when displayed,
will be recorded on the tape.
CAUTION:
Unauthorized exchanging and/or
copying of copyrighted recordings may
be copyright infringement.
46
(PLAY) on the Palmcorder.
02/06/06, 13:56