Connections - Sanyo LCD-24XR10F Instruction Manual

Cautions Before Connecting
When connecting an external device to the TV, make sure that the TV and the device are turned off.
=
Check the plugs on the ends of cables to make sure that they are the correct type before you try plugging them into jacks
=
on the TV.
Make sure that all plugs are securely inserted into the jacks. Loose connections can result in image or color problems.
=
The illustration of the external device may be different depending on your model.
=
Refer to the operating manual of the external device as well.
=
Antenna Connection
10
75-ohm coaxial cable
(round cable)
Power Connection
Household
power outlet
AC cord

Connections

· Connect one end of your antenna cable to the RF jack on the back of
the TV, then connect the other end of the cable to the antenna wall
jack.
Note:
It is recommended that the 75-ohm coaxial cable be used to eliminate
=
interference and noise which may occur due to radio wave conditions.
The antenna cable should not be bundled with the power cord and the like.
=
If the antenna is not installed properly, contact your dealer for assistance.
=
Connect the power cable to the AC IN socket on the back of the TV,
then connect the other end to a power outlet.
Note:
This product should be operated only from the type of power source indicated
=
on the marking label.
Always unplug the AC cord from power outlet when not using for a long period
=
of time.
This illustration is for reference only. The AC plug may be different on different
=
models.