NAD M50 Owner's Manual page 11

10 WIRELESS (WIFI) ANTENNA TERMINAL
• Install the supplied wireless antenna into this wireless antenna
terminal (WiFi).
• For wireless connection to be established, ensure that the supplied
wireless antenna is installed and Wireless (WiFi) broadband router
with broadband internet connection is setup and available.
11 POWER
• Supply the AC mains power to the M50.
• When the POWER switch is set to ON position, the M50 goes to
standby mode as shown by the amber status condition of the
Standby LED. Press the front panel Standby button or remote
control's [ON] button to switch ON the M50 from standby mode.
• If you intend not to use the M50 for long periods of time (such as
when on vacation), switch off the POWER switch.
• With POWER switched off, neither the front panel Standby button
nor remote control's [ON] button can activate the M50.
12 FUSE HOLDER
Only NAD service personnel can access the fuse holder in the unlikely
event a fuse may need to be replaced. Refer all servicing to authorized
NAD service centers.
13 AC MAINS INPUT
The M50 comes supplied with two separate AC power cords. Select the
AC power cord appropriate for your region.
• Before connecting the AC power cord's plug to the wall outlet,
connect firmly first the other end of the AC power cord to M50's AC
Mains input socket.
• Always disconnect the AC power cord's plug from the wall outlet
first, before disconnecting the cable from the M50's AC Mains input
socket.
IDENTIFICATION OF CONTROLS
11