Panasonic LumixDMC-FZ45 Operating Instructions Manual page 103

Start recording by pressing the motion
picture button.
A Available recording time
B Elapsed recording time
•
Release the motion picture button right after you press
it.
•
The audio is also recorded simultaneously from the
built-in microphone on this unit. (Motion pictures
cannot be recorded without audio.)
•
The recording state indicator (red) C will flash while recording motion pictures.
•
The screen will become dark momentarily, and recording will start after adjusting the
display.
•
Focus can be achieved during recording by pressing [FOCUS].
•
Focus can be set manually when [
Stop the recording by pressing the motion picture button again.
•
Sound will go off when pressing the motion picture button indicating start/stop of motion
picture recording.
Sound volume can be set in [BEEP LEVEL] (P30).
•
If the built-in memory or the card becomes full in the middle of recording, the camera
stops recording automatically.
Note
•
The screen will change as following when the motion picture button is pressed in steps
3
.
A Still picture recording
¢1
screen
B Motion Picture Mode
¢2
setting
C Motion picture recording
screen
D Still Picture Mode
¢3
setting
¢1 Set [REMAINING DISP.]
recording motion pictures.
¢2 The screen that is displayed during Motion Picture Mode setting is different depending on the
[REC MODE]
setting of the
¢3 [!] will not be displayed in the Creative Motion Picture Mode.
Advanced (Recording pictures)
MF
] is displaying.
7 7
(P32) to [ ] to display the available recording time before
.
- 103 -
A
C
(P73)
B
2
and
R1m17s R1m17s R1m17s
3s 3s 3s