Connecting The Vcr To A Satellite Receiver Or Digital Receiver - Panasonic NV-SJ410 Series Operating Instructions Manual

Connecting the VCR to a Satellite Receiver or Digital
Receiver
Satellite receiver here includes a digital receiver.
The connection method differs depending on the type of your
satellite receiver.
For details about the connection, also read the satellite
receiver's operating instructions.
If the Satellite Receiver is Equipped with a
21-pin Scart Socket
If your satellite receiver is equipped with a 21-pin Scart
socket, use a 21-pin Scart cable to connect the VCR.
For the connection to the TV, refer to pages 8 and 10.
Be sure to keep the VCR, TV and satellite receiver switched
off until you have finished all connections.
For your safety, do not connect or handle the equipment with
wet hands.
Satellite receiver (not supplied)
2
21-pin Scart socket
To an AC Mains socket
¡If your satellite
1 Connect a 21-pin Scart cable (not supplied) to the AV2
21-pin Scart socket on the VCR and to the 21-pin
Scart socket on the satellite receiver.
2 Connect the satellite receiver's mains lead to an AC
mains socket.
3 Set "AV2" to "EXT" or "TIMER".
For details, see page 36.
1
21-pin Scart cable
(not supplied)
receiver has a
VCR socket,
connect the cable
to it.
If the Satellite Receiver Is Not Equipped
with a 21-Pin Scart Socket
In case your satellite receiver is not equipped with a 21-pin
Scart socket, use the RF coaxial cable to connect it to the
VCR.
For the connection to the TV, refer to pages 8 and 10.
Be sure to keep the VCR, TV and satellite receiver switched
off until you have finished all connections.
For your safety, do not connect or handle the equipment with
wet hands.
Satellite receiver (not supplied)
3
To an AC mains socket
1 Connect the aerial lead to the Aerial Input socket on the
satellite receiver.
2 Connect the RF coaxial cable to the Aerial Output
socket on the satellite receiver and to the Aerial Input
socket on the VCR.
3 Connect the satellite receiver's mains lead to an AC
mains socket.
Hint:
¡ The RF output channel of the satellite receiver should be
adjusted away from channel 36, which is used by the
VCR, e.g. re-adjust to channel 33.
Note:
How to install the satellite receiver
Carefully observe the following points so that you can control
the satellite receiver from the VCR.
1 Place the satellite receiver on top of the VCR.
2 Move the satellite receiver back a few centimetres so that
infra-red signals emitted from the top of the VCR's front
panel can be received by the satellite receiver.
Satellite receiver
Infra-red signal
transmitter
Aerial (not supplied)
Aerial Input socket
Aerial lead
(not supplied)
1
Aerial Output
socket
2
RF coaxial cable
(not supplied)
21-pin Scart cable
or RF coaxial cable
VCR
27