[Version Disp.]/ [Format]; [Language]/ [Demo Mode] - Panasonic Lumix DMC-FP3 Operating Instructions Manual

Using [SETUP] menu
For details about the setting procedure in the [SETUP] menu. (→15)
Item
[NTSC]/[PAL]
[VIDEO OUT] ∗
• Operates when AV cable is connected.
Change the video output
format when connected
to a TV, etc. (Playback
Mode only).
[TV ASPECT]
Change the aspect ratio • Operates when AV cable is connected.
when connected to a
TV, etc. (Playback Mode
only).
Current version is displayed.
[VERSION DISP.]
Check the version of the
camera firmware.
[YES]/[NO]
[FORMAT]
• This requires a sufficiently charged battery (→9) or AC
Use when [BUILT-IN
adaptor (optional). When formatting the built-in memory,
MEMORY ERROR]
remove any cards.
or [MEMORY CARD
(Only inserted card will be formatted if present; built-in
ERROR] appears, or
memory will be formatted if no card is inserted.)
when formatting the built-
• Always format cards with this camera.
in memory or card.
• All picture data including protected pictures will be
deleted. (→76)
When a card/built-in
• Do not turn off power or perform other operations during
memory is formatted,
formatting.
the data cannot be
• Formatting the built-in memory may take several
restored. Check the
minutes.
content of the card/
• Consult your nearest Service Center if format cannot be
built-in memory
successfully completed.
carefully before
formatting.
∗ PAL video out is not available on the version DMC-FP3P sold in the U.S. and the version
DMC-FP3PC sold in Canada.
22
VQT2P49
(Continued)
Settings, notes
/
For details about the setting procedure in the [SETUP] menu. (→15)
Item
Set the language displayed on the screen.
[LANGUAGE]
Change display
language.
[DEMO MODE] [STABILIZER DEMO.]: (Only during recording)
Indicates the extent of jitter detected by the camera
View demonstration of
(Estimate)
functions.
Large ← Small → Large
• When the demo screen is displayed, touch [STABILIZER]
to switch the Optical Image Stabilizer between [ON] and
[OFF].
• Cannot be displayed in Playback Mode.
• To stop → Touch [EXIT]
• Recording and zoom cannot be performed during demo.
[AUTO DEMO]: View introductory Slide Show
[OFF]/[ON]
• To close → Press [MENU]
• If the camera is left switched on while connected to the
AC adaptor (optional) and with no card inserted, the
demo will automatically begin whenever no operations
are performed for approx. 2 minutes.
• [AUTO DEMO] cannot be displayed on external devices
such as TVs.
Settings, notes
Extent of jitter
Extent of jitter after stabilization
23
VQT2P49