Advertisement
Quick Links
6" Off rOad light
asseMbly and OperatiOn instructiOns
Due to continuing improvements, actual product may differ slightly from the product described herein.
Visit our website at: http://www.harborfreight.com
tO preVent seriOus injury, read and understand
all warnings and instructiOns befOre use.
©
Copyright
manual or any artwork contained herein may be reproduced in any shape or form
without the express written consent of Harbor Freight Tools.
for technical questions or replacement parts, please call 1-800-444-3353.
Model
3491 Mission Oaks Blvd., Camarillo, CA 93011
2007 by Harbor Freight Tools
95811
®
. All rights reserved. No portion of this
®
®
Advertisement
Related Manuals for U.S. General 6"OFF ROAD LIGHT 95811
Summary of Contents for U.S. General 6"OFF ROAD LIGHT 95811
- Page 1 Copyright 2007 by Harbor Freight Tools manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. for technical questions or replacement parts, please call 1-800-444-3353. Model 95811 ®...
-
Page 2: Specifications
Steel housing with steel lens rings and steel, rubber supported mounting Materials bracket 7” high at the bracket (mounted/surface) Dimensions 8-1/2” overall height with bracket mounted 4-5/8” Deep Voltage 12 VDC Wire connectors 6” pigtail with split-loom and brass bullet connectors. (Not a fused system) Finish Chrome housing and hardware. -
Page 3: Assembly Instructions
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible. nOte: no wires other than the attached pigtail wires are included with this light. - Page 4 Installation requires a 1/2” hole through which to insert the wiring. If your vehicle has no hole of this size, then drilling a hole will be necessary. Select a proper location to mount the Off Road Light and mark it. The Light may be either top or bottom mounted.
- Page 5 Required: Switch/Fuse (not included) rated at 15 amps or larger. Red Positive wire (not included) Black Ground Wire (6) The red Positive wire (not included) from the Light is the “HOT” wire. Use a pin con- nector or in-line splice connector (both not included) to connect the Off Road Light to your vehicle’s electric wiring system.
-
Page 6: Inspection, Maintenance, And Cleaning
OperatiOn instructiOns Start the engine, turn on the Lights by the on/off switch you installed. inspectiOn, Maintenance, and cleaning warning! Make sure the Power Switch of the Off Road Light is in its “OFF” position and that the tool is unplugged from its electrical outlet before performing any inspection, maintenance, or cleaning procedures. -
Page 7: Assembly Diagram
Holding Rings Holding Ring Screws Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of ninety days from the date of purchase. This warranty does not apply to damage due directly or indirectly, to misuse, abuse, negligence or accidents, repairs or alterations outside our facilities, or to lack of maintenance.