Advertisement
Start the engine, turn on the Lights by the on/off switch you installed.
inspectiOn, Maintenance, and cleaning
warning! Make sure the Power Switch of the Off Road Light is in its "OFF"
1.
position and that the tool is unplugged from its electrical outlet before performing
any inspection, maintenance, or cleaning procedures.
2.
befOre each use, inspect the general condition of the tool. Check for loose
screws, cracked or broken parts, damaged electrical wiring, and any other condi-
tion that may affect its safe operation. If abnormal noise or vibration occurs, have
the problem corrected before further use. do not use damaged equipment.
Maintenance type
Inspect Light for damage
(see #2, above)
Wipe off with clean, moist
cloth
problem
Off Road Light will not
turn on.
Off Road Light turns
on but flickers off and
on.
please read the fOllOwing carefully
THe MANUFACTUReR AND/OR DISTRIBUTOR HAS PROVIDeD THe PARTS LIST AND ASSeMBLY DIAGRAM
IN THIS MANUAL AS A ReFeReNCe TOOL ONLY. NeITHeR THe MANUFACTUReR OR DISTRIBUTOR MAKeS
ANY RePReSeNTATION OR WARRANTY OF ANY KIND TO THe BUYeR THAT He OR SHe IS qUALIFIeD TO
MAKe ANY RePAIRS TO THe PRODUCT, OR THAT He OR SHe IS qUALIFIeD TO RePLACe ANY PARTS OF
THe PRODUCT. IN FACT, THe MANUFACTUReR AND/OR DISTRIBUTOR exPReSSLY STATeS THAT ALL
RePAIRS AND PARTS RePLACeMeNTS SHOULD Be UNDeRTAKeN BY CeRTIFIeD AND LICeNSeD TeCHNI-
CIANS, AND NOT BY THe BUYeR. THe BUYeR ASSUMeS ALL RISK AND LIABILITY ARISING OUT OF HIS
OR HeR RePAIRS TO THe ORIGINAL PRODUCT OR RePLACeMeNT PARTS THeReTO, OR ARISING OUT OF
HIS OR HeR INSTALLATION OF RePLACeMeNT PARTS THeReTO.
for technical questions, please call 1-800-444-3353.
SKU 95811
OperatiOn instructiOns
Maintenance chart
before
after
use
X
trOubleshOOting
possible causes
1.
Wiring broken, frayed or
disconnected.
2.
Rubber Mounting Pads (7) have
vibrated loose, causing Light
connections to also work loose.
3.
Bulb is burnt out.
weekly Monthly
use
X
X
1.
Check wiring, switch, fuse, battery
connection. If any wiring is found
to be broken, frayed or damaged in
any way, replace it.
2.
Check all Rubber Mounting Pads
(7) and all electrical connections for
tightness.
3.
Replace the Halogen Bulb.
every 6
Months
X
probable solutions
yearly
X
Page 6
Advertisement
