Introduction To Controls And Components; Preparing The Remote Control - Panasonic NV-SJ200 Series Operating Instructions Manual

Introduction to Controls
and Components
VCR Operation
When you want to operate the VCR, set the VCR/TV switch
to "VCR".
Numeric buttons
To select the programme positions (1–99) of the VCR.
Example:
09:
9
1
19:
To enter numbers for various settings.
RESET button
To reset the tape counter (elapsed time) to "0:00.00".
≥ The tape counter is automatically reset to "0:00.00" when
a video cassette is inserted.
AUDIO OUT button
This button does not operate on this VCR.
No function
No function
No function
Infra-red transmitter
Child Lock Function buttons
(Convenient function to prevent unauthorized use)
This function deactivates all buttons on the VCR and the
remote control. Use this function, when you do not want
other people to operate the VCR.
To Activate the Child Lock Function:
1 Hold down the ENTER and the OFF (i) buttons
simultaneously until the "! " hold" indication appears in
the VCR display.
≥ If you press a button while the Child Lock function is
on, the "! " hold" indication appears in the VCR
display to inform you that no operation is possible.
VCR display
Indication when the Child Lock function is activated
To Cancel the Child Lock Function:
1 Hold down the ENTER and the OFF (i) buttons
simultaneously until the "! " hold" indication disappears.
Cassette compartment
Infra-red Remote Control Receiver window
CVC (Crystal View Control) Indicator
The crystal view control function ensure that you always
obtain the optimum picture quality so that you get the best
picture automatically.
While the VCR is turned on, the CVC indication
always displayed to show that the Crystal View Control is
activated.
VCR display
9
is
Preparing the Remote
Control
Inserting Remote Control Batteries
1
2
-
+
+
-
3
Notes for Battery Replacement:
≥ The service life of the batteries is approximately 1 year.
However, it varies considerably depending on the frequency
of use.
≥ When they are exhausted, replace them with two AA, UM3,
or R6 size batteries.
≥ When the batteries are exhausted, remove them
immediately and dispose of them correctly.
≥ Make sure that the batteries are inserted with the polarity
(+ and -) correctly aligned.
≥ Do not mix old battery with new battery.
≥ Do not mix different battery types, i.e. Alkaline and
Manganese.
≥ Do not use rechargeable (Ni-Cd) batteries.
≥ Do not heat or short-circuit the batteries.
≥ When you do not use the remote control for a long time,
take out the batteries and store them in a cool, dry place.
If the Sliding Cover of the Remote Control
Becomes Detached
If the sliding cover of the remote control becomes detached
accidentally, fit it securely in place by placing it on the top of
the remote control at the position shown in the illustration
below, and pushing it down until it clicks into position.
≥ It is not possible to fit the sliding cover in place by pushing
or sliding it on from the bottom end of the remote control.
Correct
1 Slide off the battery cover.
2 Insert the batteries with the
polarity (+ and -) correctly
aligned.
3 Replace the battery cover.
Wrong
5