Panasonic TTH-37PWD8EK Operating Instructions Manual page 40

Options Adjustments
Options
Off-timer function
Onscreen display
Initial INPUT
Initial VOL level
Maximum VOL level
INPUT lock
Studio W/B
Advanced PIP
Display size
Options
Button lock
Remocon User level
ID select
Remote ID
Serial ID
Slot power
V. lnstallation
Rotate
Press or button to switch between
modes.
Off On
Off
Does not rotate the image.
On
Rotates the image 180 degrees.
Press or button to switch between
modes.
Off On
Off
Sets fan to the horizontal installation
mode.
On
Sets fan to the vertical installation mode.
Notes:
• This functions when display is turned
on.
• This mode is available for TH-42PHD8EK/S,
TH-50PHD8EK/S.
• Vertical installation is available for
TH-42PWD8EK/S without this mode
setting.
• Turn up the power switch for the
upward direction when you set Display
vertically.
Press or button to switch between
modes.
Off On
Sets the panel ID Control.
Off
Disables external control by the ID.
On
Enables the external control by the ID.
Normalization
When both main unit buttons and remote control are disabled due to the "Button lock", "Remocon User level" or "Remote
ID" adjustments, set all the values "Off" so that all the buttons are enabled again.
Press the button on main unit together with
The "SHIPPING" menu is displayed and the lock is released when it disappears.
40
Press
1/2
Enable
Off
On
Sets normal two screen display mode. (see page 20)
Off
On
Off 0
Off 0
Sets Advanced PIP mode (see page 21).
Off
Off
Notes:
Off
• When "INPUT lock" is "On", you cannot use all the two screen
Off
display functions.
2/2
•
operation.
Off
Off
0 Press
Off
Off
Off
Adjusts the image display size on screen.
Off
Off
Off
Sets the normal image display size on screen.
On
Sets the image display size approximately 95 % of the normal
image display.
Notes:
• This setting is valid only when the input signals are as
follows; 525i, 525p, 625i, 625p, 750/60p, 750/50p, 1125/60i,
1125/50i, 1125/24sF, 1125/25p, 1125/24p, 1125/30p, 1250/50i
(Component Video, RGB, DVI, SDI, HDMI)
• This setting is invalid when two screen display, digital zoom
or Multi screen is selected.
• When Display size is set to "On", Pos./Size adjustment cannot
be used.
• Refer to each board's operating instruction for DVI, SDI,
HDMI's corresponding signals.
Sets panel ID number when panel is used
in "Remote ID" or "Serial ID".
Set value range: 0 - 100
(Standard value: 0)
Press
Off
Disables ID remote control functions.
You can use normal remote control operations.
On
Enable ID remote control functions.
button on the remote control and hold for more than 5 seconds.
or button to switch between modes.
Off On
, buttons are unavailable during Advanced PIP mode
or button to switch between modes.
Off On
Off
or button to switch between modes.
Off On
On