Wiring Equalizer Amp. Selector; Turntable Assembly - Aiwa PX-E855ZZ Operating Instructions Manual

Precautions
On installation
Avoid placing the turntable:
• On slanting or vibratile places
• Near electrical appliances such as a
television, hair dryer or fluorescent lamp
• Where is sunny, extremely cold or hot,
dusty and very moist
On operating voltage
Before use, check that the rated voltage of
your set matches the local voltage.
Preparations
Amplifier
4
English
On safety
• Unplug the unit when you do not intend
to use it for a long time.
• When you disconnect the unit, pull out the
cord by the plug and not by the cord itself.
On cleaning
• Before playing a record, clean the stylus
with a soft brush from back to front. Do
not touch the stylus with your finger. When
you use a fluid stylus cleaner, make sure
not to moisten the stylus too much.
To an AC outlet
• Clean the cabinet and dust cover
periodically with a soft dry cloth. A mild
detergent solution may be used, but never
use strong solvents which can damage
the surface.
Wiring the (phono)
EQUALIZER AMP. Selector
When you connect this unit to the AIWA
MIDI system* or a main system other
than the AIWA MIDI system,
set the (phono) EQUALIZER AMP. selector
as follows:
Position of EQUAL-
Connected jack of
IZER AMP. selector
amplifier
ON
VIDEO/VCR/AUX
OFF
ON
* AIWA MIDI
Note
If the sound heard is too low when the unit
is connected to PHONO jack, set the
(phono) EQUALIZER AMP. selector to ON.
Note on connections
Connect the red plug to the right-channel
jack (R), and the white plug to the left-
channel jack (L).

Turntable Assembly

1 • Hold the ribbon tape which is attached
to the belt and loop the belt over the
motor pulley. Be sure it does not twist.
A
Ribbon tape
B
Turntable belt
C
Motor pulley
• Pull the ribbon tape out of the turntable
belt.
2 Place the mat on top of the platter.
3 The dust cover can be attached and
detached. To detach it, simply lift it up
as shown in the figure.
PHONO