Memory Reset; Remote Control Code; Maintenance - Panasonic SC-AKX14 Operating Instructions Manual

Main unit displays
"NO PLAY"
• Examine the content. You can only play supported
format.
• If there are more than 255 albums or folders (audio and
non-audio), some of the MP3 files in these albums cannot
be read and played. Transfer these music albums to
another USB device. Alternatively, reformat the USB
device and save these music albums prior to saving the
other non-audio folders.
"F61"
• Examine and correct the speaker cords connection.
• Disconnect the USB device. Switch off the system and
then switch it on again.
"ERROR"
• An incorrect operation was done. Read the instructions
and try again.
"NOT MP3/ERROR"
• An unsupported MP3 format. The system will skip that
track and play the next one.
"VBR–"
• The system cannot show the remaining play time for
variable bit rate (VBR) tracks.
"NORMAL"
• The "INPUT LEVEL" of AUX source automatically
changes from "HIGH" to "NORMAL" when the system
detects distorted music sounds.
"NODEVICE"
• The USB device is not connected. Examine the
connection.
Memory reset (initialisation)
Reset the memory when the following situations occur:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
1
Disconnect the AC mains lead.
2
While you press and hold [1] on the main unit,
connect the AC mains lead again.
"– – – – – – – –" is shown.
3
Release [1].
All the settings are set back to the factory preset.
It is necessary to set the memory items again.

Remote control code

When other Panasonic equipment responds to the remote
control of this system, change the remote control code for
this system.
Preparation
Press [RADIO, EXT-IN] (main unit: [RADIO/EXT-IN]) to
select "AUX".
To set the code to "REMOTE 2"
1
Press and hold [RADIO/EXT-IN] on the main unit
and [2] on the remote control until "REMOTE 2" is
shown.
2
Press and hold [OK] and [2] for a minimum of
4 seconds.
To set the code to "REMOTE 1"
1
Press and hold [RADIO/EXT-IN] on the main unit
and [1] on the remote control until "REMOTE 1" is
shown.
2
Press and hold [OK] and [1] for a minimum of
4 seconds.

Maintenance

To clean this system, wipe with a soft, dry cloth
• Never use alcohol, paint thinner or benzine to clean this
system.
• Before using chemically treated cloth, read the
instructions that came with the cloth carefully.
11