Using Cold Water Dispenser - Samsung Refrigerator User Manual

Controlling the Refrigerator
temperature
The Refrigerator temperature can be set between
7ºC and 1ºC to suit your particular needs. Press
the Fridge button repeatedly until the desired
temperature is shown in the temperature display.
The temperature will move 1°C degrees with each
press (3°C → 2°C → 1°C → 7°C → 6°C → 5°C →
4°C → 3°C). The temperature control process for the
Fridge works just like the Freezer process.
Press the Fridge button to set your desired
temperature. After a few seconds, the Fridge will
begin adjusting towards the newly set temperature.
This will be reflected in the digital display.
- The temperature of the Freezer, fridge
or Convertible Room may rise when you
open the doors too frequently, or if a large
amount of warm or hot food is placed
inside.
- This may cause the digital display to blink. Once
the Freezer and fridge temperature return to their
normal set temperatures, the blinking will stop.
- If the blinking continues, you may need to "reset"
the Refrigerator. Try unplugging the appliance,
wait for around 10 minutes and then plug the
power cord back in.
- If there is an communication error between the
Display and Main Controller, the Convertible
Display light may blink. Once the normal set
temperatures are reached, the blinking will stop.
If the blinking continues for a long period of time,
please contact a Samsung Electronics Service
Center.
USING THE COld WATER
dISPENSER
Press the Ice / Water button to select the type of you
want.
Using the ice lever ( 1 )
Push the Ice lever dispenser ( 1 ) gently with your
glass. Ice will be released from the dispenser.
14_ operating
NO ICE
Select this if you want to turn ice
maker off
You can choose the type of ice by pushing the
cubed or crushed button first.
Using the Water lever
( 2 )
Push the Water lever
dispenser ( 2 ) gently with your
glass. Water will be released
from the dispenser.
Even if you push the water
and Ice lever simultaneously,
the dispenser operates only
the option you selected or
pushed first.
Using the Ice & Water Dispenser
together
To get Ice and water, push the Ice lever ( 1 ) first for
ice, then move your glass glass down and press the
water dispenser lever ( 2 ) for water.
Do not pull the
lever out. You could
CAUTION
damage or break the
lever's spring.
• To clean the
ice bin/bucket,
CAUTION
wash with a mild
detergent, rinse
well, and dry
thoroughly it.
Do not use harsh or abrasive cleaners or
solvents.
• When you select Cubed Ice after using the
Crushed Ice mode, a small amount of residual
crushed ice might be produced.
• In case ice doesn't come out, pull out the ice
bucket and press the test button located on the
right side of ice maker.
• Do not press the test button continuously when
the tray is filled with ice or water. Water may
overflow or ice may jam the bucket.
• Normal Use
To fill the ice bucket to maximum capacity after
installation, follow these steps:
1. Allow your refrigerator to operate and cool down
for 24 hours (or 1 full day).
- Waiting 24 hours will allow your ice maker to
cool properly.
2. Dispense 4 to 6 ice cubes into the glass.
3. After 8, and then 16 hours, dispense a full glass
of ice.
1
2
check the water
level
Test button