Using The Printer; Setting The Dip Switches - Samsung SRP-370 User Manual

1-8. Using the Printer

Control Panel
Button
The button can be disabled by the ESC c 5 command.
Press the FEED button once to advance paper one line. You can also hold down the
FEED button to feed paper continuously.
Panel lights
POWER
The POWER light is on whenever the printer is on.
ERROR
This indicates an error.
PAPER OUT
This light indicates the near end of the paper roll. Install a new paper roll and the
printer Will continue printing.
When the light blinks, it indicates the self-test printing standby state or macro
execution Standby state when the macro execution command is used.
12

1-9. Setting the DIP Switches

Serial Interface(RS-232C, RS-485) Specification
DIP Switch Set 1 Functions
Switch No. Function
SW1-1
Baud Rate Selection
SW1-2
SW1-3 Handshaking
SW1-4 Reserved
SW1-5 Cutter Function
SW1-6 Paper
SW1-7 Reserved
SW1-8 Reserved
Baud rate selection
SW1-1 SW1-2 Trans- Speed Remark
OFF OFF 9600 Baud
ON OFF 19200 Baud
OFF ON 38400 Baud
ON ON 115200 Baud Default
Dip Switch Set 2 Functions
Switch No. Function
SW2-1
SW2-2 Select Print Density
SW2-3
SW2-4 Historical Control
SW2-5 Reserved
Interface Condition
SW2-6
Selection
SW2-7 Reserved
SW2-8 Printing width
ON OFF Default
OFF
Refer to below Table
OFF
Hardware Software
OFF
(DTR/DSR) (Xon/Xoff)
-- OFF
Disable Enable OFF
2 Color Mono OFF
-- OFF
-- ON
ON OFF Default
OFF
Refer to below Table OFF
OFF
Enable Disable OFF
-- OFF
by Memory by DIP
OFF
Switch Switch
-- OFF
2" Printing 3" Printing OFF
13