Connecting Tv Signal Source - Polaroid TFT-LCD TV User Manual

System Connections
Connecting a TV Signal Source
Connect a TV signal source (antenna or analog cable) to the RF (TV) jack on the jack panel of the
unit.
After connecting to the antenna, turn on the unit, and go on with program searching, you can follow
the below steps to select channels:
When cable is connected,
1. For 0~9 channel:
Press the number buttons to select the channel X, wait three seconds and it will go to the
selected channel.
Or press the number button to select channel X, and then press the
selected channel immediately.
Or press the number buttons to input 00X, it will go to the selected channel immediately.
2. For 10~12 channel:
Press the number buttons to select channel XX, wait three seconds and it will go to the selected
channel.
Press the number buttons to select channel XX, and then press the
selected channel.
Or press the number buttons to input 0XX, it will go to the selected channel immediately.
3. For 13~99 channels:
Press the number buttons to input XX, it will go to the selected channel immediately.
Or press the number buttons to input 0XX, it will go to the selected channel immediately.
- 14 -
button to go to the
button to enter the