MATSONIC MS7057C User Manual page 35

1. Before installing an expansion card, check the documenta-
tion for the card. If the card is not Plug and Play, you may
have to manually configure the card before installation.
2. In the system case, remove the blanking plate from the slot
in the system case that corresponds to the expansion slot
that you are going to use.
3. Position the edge connector of the add-in card over the ex-
pansion slot. Position the metal bracket of the card in the
empty slot in the system case.
4. Install the edge connector of the add-in card into the expan-
sion slot. Press down quite firmly so that you are sure that
the edge connector is correctly seated in the slot.
5. Secure the metal bracket of the card in the empty slot, in the
system case, with a screw.
6. For some add-in cards, for example graphics adapters and
network adapters, you have to install drivers and software
before you can begin using the add-in card.
PC I
add-in card
M etal
bracket
Edge
C onnector
PC I slot
29