MATSONIC MS7057C User Manual page 28

1. Locate the Socket 370 and CPUFAN1.
2. Pull the Socket 370 locking lever away from the socket to un-
hook it and then raise the locking lever to the upright position.
CPU fan
connector
CPUFAN1
Socket 370 with
locking lever in
upright position
3. Identify the pin-1 corner on the Socket 370 and the pin-1 corner
on the processor. The processor pin-1 corner is beveled.
4. Matching the pin-1 corners, drop the processor into the
socket. No force is required and the processor should seat
into the socket easily.
5. Swing the locking lever down and hook it under the latch on
the edge of the socket. This locks the processor in place.
6. Plug the heatsink/cooling fan power cable into the
CPUFAN1 connector on the mainboard.
The mainboard must be configured to deliver the correct clock
speed and the correct frontside bus frequency for the kind of
processor that you have installed. You can do this by using the
CMOS (BIOS) Setup Utility. The first time you start the system,
immediately enter the Setup Utility and make the appropriate
settings. See Chapter 3 for more information.
Socket 370
processor with
heatsink/cooling
fan attached
22