Vcr Plus+ Programming With The Power Off - Pioneer DVR-320 Operating Instructions Manual

06 Recording
1 Press 'VCR Plus+' to display the VCR Plus+
program screen.
You can also access this screen from the Home Menu
(press HOME MENU, select Timer Recording, then VCR
Plus+).
VCR Plus+
PlusCode#
Rec Mode
Rec Times
• Use the number buttons to enter the PlusCode
number. (To clear the last digit entered, press
CLEAR.)
• Press REC MODE to select FINE, SP, LP, EP or AUTO
(See Recording time and picture quality on page 42). If
Manual Recording is on, then you can also select the
MN setting.
• Use the
Once, Daily or Weekly recording option.
2 After making the settings, press ENTER.
The program details are shown at the bottom of the
screen for a few seconds then the screen is automatically
exited.
• If you haven't set up the guide channels (or at least
the guide channel for the PlusCode number that you
entered), the recorder will prompt you to enter the
channel number that the TV program is showing on.
48
En
VCR Plus+
CLEAR
ENTER
HOME
MENU
REC MODE
0 9
3 9 9 2 4 to input
REC MODE
to change
MN21
to change level
Once Daily Weekly to change
(cursor left/right) buttons to select the
Tip
• You can check the timer program settings by
pressing TIMER REC to display the timer recording
screen.

VCR Plus+ programming with the power off

You can enter a PlusCode number when the recorder is
in standby.
VCR Plus+
Important
• You can't use this feature until you have set up the
guide channels. See VCR Plus+ CH Setting on
page 76.
• You can't change the recording mode.
• You can't program daily or weekly timer recordings.
1 Press 'VCR Plus+'.
The front panel display shows the current recording
mode and prompts you to enter the PlusCode number.
P L US CODE
2 Use the number buttons to enter the PlusCode
number.
• To clear the last digit entered, press CLEAR.
3 Press ENTER.
The display shows the timer settings:
Date Start time End time
• If CODE ERROR appears in the display, check that
the PlusCode number is correct and that the guide
channel is set (see VCR Plus+ CH Setting on
page 76), then set the timer recording again.
• If CAN'T SET appears in the display, it means that
although you entered a valid PlusCode number, the
program has already finished.
CLEAR
ENTER
2 9 32 4
Recording channel.