Specifications; Instructions For Putting Into Use - U.S. General 99925 Set Up And Operating Instructions Manual

speciFications

Electrical Requirements 120 V~ / 60 Hz / 15 A
Air Outlet Size
Air Pressure
Air Tank Capacity
Air Flow Capacity
Oil Tank Capacity
Oil Type
Sound Level
Motor
unpacKing
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at the number shown on the
cover of this manual as soon as possible.
instructions For
putting into use
read the entire important
saFetY inFormation
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
From accidental
operation:
turn the power switch of the
tool to its "oFF" position and
unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
SKU 99925
Two 1/4" 18 NPT
Auto Shut-off at 125
PSI
Restart at 90 PSI
25 Gallons
5.3 CFM @ 40 PSI
4.0 CFM @ 90 PSI
1 Quart
30W Non-Detergent
Compressor Oil
98 dB @ 3'
3.5 HP
to preVent
serious injurY
For technical questions, please call 1-800-444-3353.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
assembly
1. Thread the Intake Filter (16) onto the
side of the motor, as shown below.
2. Connect one or two 1/4" NPT air
hoses (rated 165 PSI or higher) to
the Quick Couplers (25). See photo
next page. The air hose must be
long enough to reach the work area
with enough extra length to allow free
movement while working.
3. Incorporate an in-line oiler, shut-off
valve, regulator with pressure gauge,
and filter for best service, as shown in
the diagram below. An in-line shutoff
valve is an important safety device
because it controls the air supply
even if the air hose is ruptured.
intake Filter (16)
REV 08j
Page 7