Table of Contents
Advertisement
the oil appears in the middle of the circle in the Oil Sight Gauge.
3.
If the oil level is below the middle of the circle in the Oil Window (B23), UN-
SCREW (do not pull) the Oil Cap (23) out of the Oil Fill Hole.
the Oil Fill Hole until the level of oil reaches the middle of the circle as indicated
in the Oil Window. Do not overfill. Note: Optimal capacity of the oil reservoir is
21.5 ounces.
not to strip the plastic threads.
FRONT VIEW
4.
CAUTION: ALWAYS make sure the crankcase of the Gasoline Engine
(5) is filled to the proper level with a premium quality, 30-weight, non-
detergent engine oil prior to starting the engine. Failure to do so will result
in damage to the Air Compressor and void its warranty. Refer to the engine
manufacturer's instruction manual for further information.
5.
Check to make sure the Drain Plugs on both Air Tanks (31) are fully closed.
(See Figures D, and E.)
6.
Turn the Tool Pressure Valve (13) clockwise all the way to allow compressed air
to build up in the Air Tanks (31). (See Figure B.)
SKU 90749
For technical questions, please call 1-800-444-3353.
Then screw the Oil Cap back onto the Oil Fill Hole, being careful
FIGURE C
TYPICAL DRAIN PLUGS
1/4" HEX
(See Figure C.)
OIL CAP
(23)
OIL
WINDOW
(B23)
PIPE
FIGURE D
(See Figure C.)
Next, add oil into
SIDE VIEW
REV 02/04
Page 8
Advertisement
Table of Contents
