Panasonic Viera TX-P42ST30E Operating Instructions Manual page 37

Menu Item
P-NR
3D-COMB
3D Settings
Screen Display
Intelligent Frame
Creation
24p Smooth Film
Film Cadence
Detection
3D Refresh Rate
Resolution Enhancer
Side Panel
Adjustments / Configurations (alternatives)
Picture Noise Reduction
Automatically reduces unwanted picture noise and flicker noise in the contoured parts
of a picture [Off] / [Min] / [Mid] / [Max]
Makes still or slow moving pictures look more vivid [Off] / [On]
•
Occasionally, whilst viewing still or slow moving pictures, colour patterning may be
seen. Set to [On] to display sharper and more accurate colours.
•
For PAL or NTSC signal reception only
•
Not valid on 3D, RGB, Component, HDMI and Media Player
Adjusts and sets to view 3D images (p. 32)
Turns the screen off when you select [Off ]
[Off] / [On]
•
The sound is active even if the screen turns off.
•
Press any buttons (except Standby) to turn the screen on.
•
This function is effective in reducing power consumption when listening to the sound
without watching the TV screen.
Automatically compensates the picture frame rate and removes juddering movements
to make the images smooth [Off] / [Mid] / [Max]
•
Depending on the contents, images may be noisy. To prevent the noise, change the
setting.
•
This function is not available for selection (default to [Off ]) when [Viewing Mode] is
set to [Game] or in the mode of VIERA Connect.
Automatically compensates the picture frame rate to make the 24p source movie
images smooth [Off] / [Mid] / [Max]
•
This is available only for 24p signal input and displayed instead of [Intelligent Frame
Creation].
•
This function is not available for selection (default to [Off ]) when [Viewing Mode] is
set to [Game] or in the mode of VIERA Connect.
Automatically makes the film source movie images clear [Off] / [On]
•
This function is available for the interlaced signal (except when [Viewing Mode] is set
to [Game]).
Reduces juddering and flicker noises of the 3D images [Auto] / [100Hz]
•
If the room is lit by fluorescent lights / dimmers (50 Hz) and light appears to flicker
when using the 3D Eyewear, set to [100Hz].
Enhances the picture resolution to make the image sharper [Off] / [Mid] / [Max]
•
This function is available for SD (Standard definition) signal.
•
As for HD (High definition) signal, this function is available when aspect mode is set
to [16:9] ([16:9 Overscan] is set to [On]), [4:3 Full] or [Zoom].
•
Not valid on Media Player and VIERA Connect
Increases the brightness of the side panel [Off] / [Low] / [Mid] / [High]
•
The recommended setting is [High] to prevent panel "image retention".
37