Panasonic Viera TX-P42ST30E Operating Instructions Manual page 101

Problem
Cannot connect to the
network
Cannot operate
VIERA Connect
The TV does not switch On
The TV goes into Standby
mode
The remote control does not
work or is intermittent
Parts of the TV become hot
Permanently lit spots on
screen
Overcurrent error message
appears
An error message appears
•
Check the LAN cable or Wireless LAN Adaptor is connected properly.
•
Check the connections and settings.
•
Check the network equipment and network environment.
•
The router may not be set to issue IP address automatically. If the network
administrator prefers to allocate an IP address, set an IP address manually.
•
The router may be using MAC address filtering (security setting).
Confirm the MAC Address of this TV (p. 78) and set the router to be able to use it.
•
If the problem persists, consult your Internet Service Provider or telecommunications
company.
•
Check the connections and settings.
•
The server or connected line might be busy now.
•
Check the mains lead is plugged into the socket outlet.
•
Auto power standby function is activated.
•
The TV enters Standby mode about 30 minutes after analogue broadcasting ends.
•
Are the batteries installed correctly?
•
Has the TV been switched On?
•
The batteries may be running low. Replace them.
•
Point the remote control directly at the front of the TV (within about 7 m and a 30
degree angle of the front of the TV).
•
Situate the TV away from sunshine or other sources of bright light not to shine on the
TV's remote control signal receiver.
•
Even when the temperature of parts of the front, top and rear panels has risen, these
temperature rises will not pose any problems in terms of performance or quality.
•
Due to production process involved in this technology this may result in some pixels
which are permanently lit or unlit. This is not a malfunction.
•
The connected USB device might cause this error. Remove the device and turn the TV
Off with Mains power On / Off switch, then turn it On again.
•
Check if foreign objects are inside the USB port.
•
Follow the message's instructions.
•
If the problem persists, contact your local Panasonic dealer or the authorized Service
Centre.
Actions
(p. 73 - 78)
(p. 73 - 78)
(p. 10)
(p. 7)
(p. 73)
(p. 75)
101