Panasonic Viera TX-P42ST30B Operating Instructions Manual page 80

Reduce unnecessary power consumption in standby [Standby Power Save]
Set Standby Power Save [On] in the Setup Menu to use this function
The power consumption in Standby mode of the connected equipment is controlled in synchronization
with the TV On / Off state.
When the TV is set to Standby mode, the connected equipment is automatically set to Standby and the
power consumption in Standby mode of the connected equipment is automatically minimised.
When the TV is turned on and the connected equipment is still in Standby mode, the power
consumption of the connected equipment is increased to reduce the startup time.
•
This function is effective if the connected equipment can change the power consumption in Standby
mode and is set to higher consumption.
Auto standby for unnecessary equipment [Intelligent Auto Standby]
Set Intelligent Auto Standby [On (With reminder)] or [On (No reminder)] in the Setup Menu to use
this function [Intelligent Auto Standby] (p. 39)
When the TV is On, non-watched or non-used connected equipment goes into Standby mode
automatically to reduce power consumption. For example, when the input mode is switched from HDMI,
the connected equipment will go into Standby mode / when Speaker Selection is changed to [TV], the
Player theatre will go into Standby mode (except when watching a disc).
•
If you select [On (With reminder)], the on screen message will be displayed before the connected
equipment turns to Standby.
•
This function may not work properly depending on the connected equipment. If required, set to [Off].
Direct TV Recording
Recording the current programme on a DIGA Recorder immediately.
•
If you connect a variety of recorders including other manufacturers' recorders at the same time, please
connect the DIGA Recorder to the TV's lower HDMI terminal number. For example, if you use HDMI1
and HDMI2 for two recorders, connect the DIGA Recorder to HDMI1.
•
If Direct TV Recording does not operate, check the settings and the equipment
"Summary of Q-Link and VIERA Link features" (p. 76, 77), "Preparations" (p. 79)
•
If you wish to record a programme that the DIGA Recorder does not support, a SCART connection is
required and the programme is recorded by Q-Link function (p. 78).
•
Depending on the programme, a SCART connection may be required to record.
•
Changing channel or turning off the TV is available while the recorder is recording from its own tuner.
•
Changing channel is not available while the recorder is recording from the TV tuner.
■
To stop recording
Select [Stop] in [Direct TV Rec]
VIERA Link Menu
Pause Live TV
Direct TV Rec
VIERA Link Control
Speaker Selection
•
You can also stop recording directly.
Unlock the tuner
Press EXIT to unlock and stop recording
80
- What you see is What you record
Display [VIERA Link Menu]
1
Select [Direct TV Rec] and start recording
2
VIERA Link Menu
Pause Live TV
Direct TV Rec
VIERA Link Control
Speaker Selection
Start
Stop
Recorder
Home Cinema
Tuner Locked
[Direct TV Rec]
Start
Start
Recorder
Home Cinema
select
access / stop
EXIT
[Standby Power Save] (p. 39)
select
access / start
•
You can also start recording directly.
DIRECT TV REC