Table of Contents
Advertisement
Component Resolution
This sets the video output resolution when using the component
video terminal.
[576i/480i]
[576p/480p]
≥If it is set to "720p", images other than "720p" will be output as
"1080i".
≥Press the [∫] and [1] (PLAY) for more than 5 seconds when the
image is disturbed by changing the setting. It will be set to "576i/
480i".
AV1 Output
Set according to the terminal of the connected TV.
Select "Video" or "S Video" for component output (progressive
output).
If this unit is connected with an HDMI cable, you cannot select
"RGB 1" or "RGB 2".
When a decoder is connected, do not set to "RGB 1".
[Video]
Select when a TV is connected that can receive a composite signal.
[S Video]
Select when a TV is connected that can receive an S Video
signal.
[RGB 1]
Select when a TV is connected that can receive an RGB signal.
If you always would like to view the picture from the unit in RGB
signal, select this mode. The TV screen will automatically switch
to display the picture from the unit when the unit is turned on.
[RGB 2]
Select when a TV is connected that can receive an RGB signal.
If you would like to switch to display the picture from the unit only
when playback or viewing menus, select this mode.
AV2 Settings
Set to match the connected equipment.
≥Press [OK] to show the following settings.
AV2 Input
Set to "RGB/Video" or "RGB" when receiving or recording RGB
output from external equipment.
[RGB/Video]
[RGB]
Ext Link
This setting cannot be made when the "TV System" is set to
"NTSC" (
90).
[Ext Link 1]
When a digital satellite receiver which transmits a
special control signal recordings via the 21-pin
Scart cable is connected.
Start and stop timings of recording are controlled
by the control signal.
[Ext Link 2]
When external equipment with a timer function is
connected.
When it turns on, recording starts.
When it turns off, recording stops.
AV Input Colour System
Select the video system type when receiving or recording PAL or
SECAM signals from external equipment.
[Automatic]
This unit automatically distinguishes PAL and
SECAM signals.
[PAL]
For receiving PAL signals.
[SECAM]
For receiving SECAM signals.
[720p]
[1080i]
[Video]
[S Video]
Network Settings
IP Address/DNS Settings
≥Press [OK] to show the following settings.
Connection Test
[--]
IP Address Auto-assignment
[On]
[Off]
IP Address
[---.---.---.---]
Subnet Mask
[---.---.---.---]
Gateway Address
[---.---.---.---]
DNS-IP Auto-assignment
[On]
[Off]
Primary DNS
[---.---.---.---]
Secondary DNS
[---.---.---.---]
Connection Speed Auto-configure
[On]
[Off]
Connection Speed Setting
This is enabled only when "Connection Speed Auto-configure" is
turned "Off".
[10BASE half duplex]
[100BASE half duplex]
Proxy Server Settings
(
≥Press [OK] to show the following settings.
Initialize
Set the setting of the "Proxy Server Settings" back.
Proxy Address
(The initial setting is blank.)
Proxy Port Number
(The initial setting is "0".)
93
(
)
[10BASE full duplex]
[100BASE full duplex]
94
)
RQT9132
91
Advertisement
Table of Contents
