Displaying Pc Screen On Tv - Panasonic Viera TX-L32E3B Operating Instructions Manual

Displaying PC Screen on TV

The screen of the PC connected to the TV can be displayed on the TV.
You can also listen to PC sound with the audio cable connected.
To connect PC p. 68
INPUT
TV AV
ASPECT MENU N DIRECT TV REC
EXIT
OPTION RETURN
To return to TV
TV
PC menu setting (changed as desired)
To make settings "How to Use Menu Functions" (p. 27)
Menu Item
R-Gain
G-Gain
B-Gain
R-Cutoff
G-Cutoff
B-Cutoff
Reset to Defaults
Gamma
Reset to Defaults
Input Resolution
Clock
H-pos
V-pos
Clock Phase
Sync
Reset to Defaults
Other items p. 28 - 32
Note
For HDMI-compatible PC, possible to connect to HDMI terminals (HDMI1 / HDMI2 / HDMI3) by using HDMI cable (p. 72).
Select the external input
1
AV
Select [PC]
2
Input Selection
AV1
AV2
COMPONENT
PC
HDMI1
HDMI2
HDMI3
TV
SD Card
Adjustments / Configurations (alternatives)
Adjusts the white balance for red areas
Adjusts the white balance for green areas
Adjusts the white balance for blue areas
Adjusts the white balance for red areas
Adjusts the white balance for green areas
Adjusts the white balance for blue areas
Press the OK button to reset to the default White Balance
Switches the gamma curve [1.8] / [2.0] / [2.2] / [2.4] / [2.6]
Please note the numerical values are reference for the adjustment.
Press the OK button to reset to the default Gamma
Switches to a wide view
VGA (640 × 480 pixels), WVGA (852 × 480 pixels),
XGA (1,024 × 768 pixels), WXGA (1,280 × 768 pixels, 1,366 × 768 pixels)
Options change depending on signals
Set to the minimum level if noise occurs
Adjusts horizontal position
Adjusts vertical position
Eliminates flicker and distortion
Adjust after Clock adjustment
Chooses another synchronous signal if the image is distorted [H & V] / [On Green]
H & V : by the horizontal and vertical signals from your PC
On Green : by the green signal from your PC (if available)
Press the OK button to reset to the default PC Setup settings
select
access
Corresponding signals p. 73
If "H-freq. " or "V-freq. " is shown in red,
the signals may not be supported.
Set to the minimum level if noise occurs
51