Water Filtration System (Option); Brewing Coffee Now - Mr. Coffee ES series User Manual

Water Filtration System (Option)

Congratulations! You are the owner of the MR. COFFEE
Water Filtration System! This carbon-based water filter
improves the taste of your coffee by removing up
to 97% of the chlorine from the water that you use
to brew your coffee.
To use the water filtration system in your MR. COFFEE
Coffeemaker, please follow these steps:
First look for the MR. COFFEE Filtration Friendly symbol,
on the bottom of your brew basket. If you do not see this
symbol, please call 1-800-MR COFFEE (1-800-672-6333).
1. If you have located the symbol , remove the gray disk
cover from your water filtration system as shown in
Diagram 1. Insert disk into the frame and replace cover.
2. Using the red indicator on the water filter, align the
indicator to the letter on the frame that corresponds
with the month that you are using the disk for the
first time. This serves to remind you to change the
disk every month.
3. Place a MR. COFFEE paper or permanent filter in the
brew basket. Place coffee grounds in the paper or
permanent filter.
For optimal results, use the water filtration
system with a permanent filter.
4. Place the MR. COFFEE Water Filter in the brew basket,
noting which side is up, as indicated on the water
filter, and making sure the water filter is level.
5. Close the brew basket or lid. You are now ready to
brew great tasting coffee. If the brew basket or lid
does not close properly, then repeat Steps 4 – 5
to ensure that the filter has been properly inserted.
6. When you are done brewing your coffee, rinse the
water filter with fresh water. Do not put your water
filter in the dishwasher.
N : Your water filtration disk will need to be replaced
OTE
once a month (approximately 30 brew cycles).
Replacement water filtration disks can be purchased
through your local retailer or by calling 1-800-MR COFFEE
(1-800-672-6333).
10
®
1
Frame
Filter Disk
®
Disk Cover
,
Red
Indicator
2
3
4
5

Brewing Coffee Now

For Switch Models (ES12 & ES13):
Push the switch so the light illuminates.
This light indicates that the coffeemaker is on and the
brew cycle will begin. When the coffee stops flowing,
the brew cycle is complete.
While the coffee is brewing, the Pause 'n
Serve feature allows you to sneak a cup
of coffee from the decanter. REPLACE
THE DECANTER ON THE WARMING PLATE
WITHIN 30 SECONDS TO PREVENT
OVERFLOW AND POSSIBLE INJURY.
To turn off the coffeemaker, push the switch
so the light is no longer illuminated.
If the brew basket overflows or fails to empty
into the decanter, do not open the brew
basket. Turn off the coffeemaker. Unplug
the coffeemaker and wait for the contents
to cool before handling.
For Programmable Models (ESX20 & ESX23):
Press the ON button when ready to start brewing.
Your coffeemaker will keep your coffee hot
for 2 hours, then automatically shut off.
To turn the coffeemaker off, push the OFF button.
For Programmable Models (ESX39 & ESX40):
Press the SELECT button until the ON/OFF Indicator
light is illuminated. Your coffeemaker will now begin
brewing.
Your coffeemaker will keep your coffee hot
for 2 hours, then automatically shut off.
To turn the coffeemaker off, press the SELECT
button until the ON/OFF Indicator light is off.
clean
11