Ip Address Settings - Mitsubishi Electric XD550U User Manual

Network settings (continued)
5. Select OK, and NEW NETWORK PASSWORD
screen appears if the entered password is correct.
• If the entered password is not correct,
CURRENT NETWORK PASSWORD screen
appears again.
6. Enter the NEW NETWORK PASSWORD and
CONFIRM NETWORK PASSWORD.
• Password can be set using up to 32 characters
including alphabets (capital/small) or numeric
characters.
 key:
Shifting the position of enter
cursor to the left for each
character.
 key:
Shifting the position of enter
cursor to the right for each
character.
key: Shifting the position of
enter cursor between NEW
NETWORK PASSWORD
and CONFIRM NETWORK
PASSWORD.
DEL key: Deleting the character in the
position of enter cursor for each
character.
caps/CAPS key: Switching an alphabet character
to CAPITAL or small.
CLEAR key: Deleting all the entered
characters.
7. When NEW NETWORK PASSWORD and CONFIRM
NETWORK PASSWORD are matched, the setting is
completed after changing the Network Password.
• If the entered content is not matched, NEW
NETWORK PASSWORD screen appears again
after an error dialog is displayed.
• It may take some time to refl ect the settings.
IP Confi g settings
(See page 21 for menu setting.)
1. Display the Network Confi g menu.
2. Press the  or  button to select IP Confi g.
IP Config
3. Press the ENTER button.
• IP Confi g menu appears.
DHCP
IP Address
Subnet Mask
Default Gateway
MAC Address
DHCP Function
Start IP Address
End IP Address
IP Config Setup
Setting or clearing DHCP
1. Display the IP Confi g menu.
2. Press the  or  button to select DHCP.
DHCP
3. Press the  or  button to select On
4. Press the ENTER button.
• To cancel the setting, press the MENU button.
• When DHCP is set to On, IP Address, Subnet
Mask, and Default Gateway cannot be set. If
you want to set these settings, set DHCP to Off
and perform the IP settings as follows.

IP Address settings

1. Display the IP Confi g menu.
2. Press the  or  button to select IP Address.
IP Address
3. Press the ENTER button.
• The fi rst octet is selected.
IP Address
4. Press the  or  button to select the numeric
value.
5. Press the  or  button to select the octet.
• The second or fi nal octet is selected.
IP Address
6. Press the ENTER button.
• To cancel the setting, press the MENU button.
• Set the numeric value within the range from 0 to
255. However, set the numeric value for the fi nal
octet within the range from 1 to 254.
EN-34
OK
IP Config
On
169 254
- -
255 255
- -
169 254
- -
xx-xx-xx-xx-xx-xx
Off
169 - 254 -
169 254 254
- -
OK
Adjust Exit
MENU
Select
On
169 254
- -
169 254
- -
169 254
- -
0 220
-
0 0
-
0 1
-
0 221
-
254
-
or Off .
0 220
-
0 220
-
0 220
-