Installation Menu - Mitsubishi Electric XD550U User Manual

Menu operation (continued)

Installation menu

ITEM
Menu Position
Lamp Mode
Standby Mode
Image Reverse
Auto Power On
Auto Power Off
Auto Keystone
Language
Reset All
• By default, the Lamp Mode is set to Standard. The Lamp Mode is set to either Standard or Low depending on the setting last
selected, and you cannot switch the Lamp Mode in about one minute after the lamp is on.
Menu Position
Lamp Mode
Standby Mode
Image Reverse
Auto Power On
Auto Power Off
Auto Keystone
Language
Reset All
SETTING
5 options
Standard
Low
Low
LAN
Speaker Out
Monitor Out
Off
Mirror
Invert
Mirror Invert
On / Off
Off / 5-60 Min
On / Off
18 languages
OK
Installation
Upper Left
Standard
Low
Off
Off
5Min
Off
English
OK
Adjust Exit
MENU
Select
FUNCTION
Use this setting to change the position of the menu on the screen.
Select this option when you want to view images in a well-lit room.
Select to moderate the intensity of the lamp. The operating sound is reduced
and the lamp lifetime becomes longer.
• When this mode is switched, projected images may fl icker.
• If this mode is frequently switched, the lamp may be deteriorated.
Select this option when you don't use the LAN control, speaker output and
monitor output during power standby. This option disables them and reduces
the power consumption during the power standby.
Select this option when you control the projector via the LAN during power
standby.
Select this option when you want to output audio from the speaker during
power standby.
Select this option when you want to output video signal from the MONITOR
OUT terminal during power standby.
Select this setting when you want to view images from the front with the
projector set on the fl oor.
Select this setting when you want to view images from behind the screen with
the projector set on the fl oor.
Select this setting when you want to view images from behind the screen with
the projector set at the ceiling.
Select this setting when you want to view images from the front with the
projector set at the ceiling.
When this mode is set to On, the lamp is automatically lit when the power
cord is plugged in the wall outlet. Select On when you set the projector at the
ceiling.
• When the lamp is off, the projector is in standby. Use the remote control to
turn on the lamp.
Select this option for use at an altitude of 2000 to 2700 meters above the sea
level.
Selects a desired timer setting until the projector enters the standby mode
when there is no signal input from the source.
Select Auto Keystone function.
Selects a desired language for the menu.
Resets all menu settings except for Password and Language to the default.
EN-26