Panasonic Viera TH-42PV700H Operating Instructions Manual page 36

Technical Information
You can watch two images at once. (p. 13)
•
The same input mode cannot be displayed at once. (TH-42PV700MR, TH-50PV700MR only)
•
The sound is active for main screen only in multi window.
•
You cannot change the aspect ratio in multi window.
•
Multi window cannot be used with PC, SD card, HDMI (available for main screen only) or 1080p signal from
Component (Y, P
•
Some signals are reformatted for suitable viewing on your display.
•
The display timeout for the input mode or programme position can be adjusted by "Banner Display Timeout" in
Setup Menu (p. 21).
HDMI connections to some Panasonic equipment allow you to interface them automatically. (p. 30)
•
This function may not work normally depending on the equipment condition.
•
Image or sound may not be available for the fi rst few seconds when the playback starts.
•
Image or sound may not be available for the fi rst few seconds when Input mode is switched.
•
Volume function will be displayed when adjusting the volume of the equipment.
•
Easy playback is also available by using the remote control for Player theatre. Read the manuals of the
equipment.
•
If you connect the same kind of equipment at once (for example: one DIGA to HDMI1 / another DIGA to HDMI2),
VIERA Link is available for the terminal with the smaller number.
•
"HDAVI Control 2" is the newest standard (current as of February, 2007) for Panasonic's HDAVI Control
compatible equipment. This standard is compatible with Panasonic's conventional HDAVI equipment.
When you receive the stereo / bilingual sound system, sound output modes can be selected by pressing the
Stereo / Bilingual Sound Selection button.
Audio Signal
Mode Indicator
NICAM .......Used in New Zealand, Singapore, Hong Kong etc.
Type of broadcast
Mode Indicator
A2(German) .......Used in Australia, Malaysia etc.
Type of broadcast
Mode Indicator
Note
•
If the stereo signal is poor or the receiving conditions are not optimum or if STEREO:MONO automatic switching
occurs, it is recommended you switch from STEREO to MONO.
•
Even when the contents of the receiving signal undergo changes, selection mode is kept intact.
•
When the receiving conditions deteriorate, listening will be easier if the mode is set to the MONO position, using
the stereo / bilingual sound selection button.
•
DUAL, also known as DUAL MONO or as BILINGUAL is not currently transmitted in some countries.
36
/C , P /C ).
B B R R
VIERA Link "
Stereo / Bilingual Sound Selection
STEREO
Regular broadcast
Regular + NICAM MONO
(Standard Audio)
No Indicator
Regular broadcast BILINGUAL or DUAL MONO:
(Standard Audio)
No Indicator
Multi Window
Control
MAIN
I
I
I
NICAM STEREO
(MAIN )
I
I
MAIN / SUB
I II
I II
"
TM
SUB
MONO
II
II
NICAM DUAL MONO
(MAIN
I
STEREO
/ SUB )
I II
II