Related Manuals for Miele DA 430-4 EXT
Summary of Contents for Miele DA 430-4 EXT
- Page 1 Operating and installation instructions Cooker hood DA 430-4 DA 430-4 EXT To avoid the risk of accidents GiWOZ or damage to this appliance it is to read these instructions before it is installed and used for the first time. M.-Nr. 06 748 870...
-
Page 2: Table Of Contents
......... . 3 . - Page 3 Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment. disposal, and can normally be They are, however, essential for the recycled.
- Page 4 This appliance complies with all Before connecting the appliance to relevant local and national safety the mains supply, make sure that requirements. Inappropriate use the connection details given on the can, however, lead to personal injury data plate correspond with the on-site and damage to property.
- Page 5 These models may only be combined Do not use the cooker hood without with a Miele external motor. the grease filter and outer filter in place. This way you will avoid the risk of grease and dirt getting into the...
- Page 6 These can be obtained from the Miele Spare Parts department or from recognising the dangers of misuse. builders' merchants.
- Page 7 In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the extractor and the heater are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
- Page 8 The Miele DSM 400 control module offers the possibility of combining other components with the cooker hood (see "Operation with Control module DSM 400").
- Page 9 The cooker hood works with ( ...EXT models only) The EXT models are designed to be The air is drawn in and cleaned by the connected to an external fan located stainless steel outer filter and the outside the room. grease filter, and then directed outside.
- Page 11 The indicator lamp for the grease filter touch control lights up when the grease filter and the outer filter need to be with decor inserts available as optional cleaned. extras. The touch control is used to reset the Maximum load bearing capacity is 8 kg operating hours counter every time the when used as shelf.
-
Page 12: Run-On Option
The indicator lamp will come on. If the cooker hood has been connected to a window contact switch via the Miele DSM 400 control ^ Press the run-on option control for module, then the fan cannot be approx. 10 seconds. The first fan switched on if the window is shut. -
Page 13: To Switch The Fan Off
It is advisable to leave the fan running for a few minutes after cooking has finished to neutralise any lingering odours in the air. The indicator lamps for fan power levels I and IV will flash if the automatic The fan can be set to switch off switch-off for the Intensive setting is not automatically after either 5 or 15 activated. - Page 14 The hob lighting can be switched on and off independently of the fan. ^ Press the lighting touch control to switch on the hob lighting. The indicator lamp will come on. ^ Press the hob lighting control to switch the lighting off. The indicator lamp will go out.
-
Page 15: Filter Operating Hours Counter
The number of hours the appliance has been in operation is stored in memory. To check the percentage of time set already used: The operating hours counter tells you when the grease filter the outer filter need to be cleaned. ^ Press the On/Off control to switch the fan on. - Page 16 The operating hours counter for the grease filter is set at the factory for 30 / indicator lamps show the time hours. The time set can be lengthened which has been set: or shortened to suit the type of cooking 1st lamp from the left = 20 hours you do.
- Page 17 Stainless steel surfaces can be cleaned the mains fuse is disconnected, using the Miele E-Cloth, or with a proprietary non-abrasive cleaning agent designed specifically for use on the screw-out fuse is removed stainless steel.
- Page 18 The decor inserts can be removed to make it easier to clean the canopy. When handling them, take care not to drop the decor inserts onto the hob. The tool supplied with the cooker hood can be used to help with this. The inserts are designed so that the angled edges face downwards.
- Page 19 Installing the side inserts The controls may suffer discolouration or damage if soiling is left on them for too long. Remove any soiling straight away. Observe the General notes on cleaning earlier in this section. Do not use too much water when cleaning the controls.
- Page 20 Both the outer filter and the grease filter should be cleaned. ^ Clean the grease filter and the outer An oversaturated filter is a fire filter with a soft nylon brush in a mild hazard. solution of hot water and a little washing-up liquid.
-
Page 21: Housing
^ After cleaning, leave the filters to dry for a while on an absorbent surface before putting them back in place. ^ When removing the filters for ^ After replacing the grease and the cleaning, also clean off any residues of oil or fat from the now accessible outer filter, press the grease filter inside of the housing to prevent the... - Page 22 Before any cleaning or maintenance work, the cooker hood must be disconnected from the mains supply. Ensure that: it is switched off at the isolator, ^ Pull it out on this side as far as it will come, and hold firmly with one hand. the fuse is withdrawn from the With your other hand, turn the lamp a fused spur connection unit,...
- Page 23 In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer – The Miele Service Department (see back cover for address). When contacting your Dealer or the Service Department, please quote the model and serial number of your appliance.
- Page 24 safety distances between the top of a cooker or hob and the bottom of the cooker hood are as follows, unless a greater distance is specified by the manufacturer of your cooking appliance: 550 mm above electric hobs and cookers 650 mm above gas hobs and cookers...
- Page 25 Before installation, it is important to read the information given on the following pages as well as the "Appliance dimensions" and the "Warning and Safety instructions" at to use in the event of an the beginning of this booklet. uneven ceiling. This is particularly crucial when using the cooker hood at the same time as a heating appliance that...
- Page 26 per metre. Important: To avoid the danger of This is to ensure that condensate toxic fumes, please observe the cannot drain back into the cooker Warning and Safety instructions. hood. This is especially crucial when using the cooker hood at the same time as –...
- Page 27 Cooker hoods designed for use with an external motor (...EXT models) have an If the exhaust ducting is to run through integrated condensate trap. rooms, ceiling space etc. where there may be great variations in temperature between the different areas, the problem of condensation will need to (optional accessory) be addressed.
- Page 28 If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national For extra safety it is advisable to install and local safety regulations a residual current device (RCD) with a...
- Page 29 The Miele DSM 400 control module can If the control module is be used to combine the cooker hood disconnected in order to operate the with other components. cooker hood without the window It enables the following: contact switch (e.g. after moving...
-
Page 30: Installation Instructions
The control module can be used to switch on the cooker hood lighting and also to dim it (depending on model) via a light switch in the house. The control module is fitted in the tower after the cover plate has been unscrewed from the ceiling. - Page 31 DA 430-4....29 kg DA 430-4 EXT ....26 kg Exhaust system ducting C 150 mm: Level I .
- Page 32 Alteration rights reserved / 3006 M.-Nr. 06 748 870 / 00 en - GB...