Table of Contents
Advertisement
Cleaning and care
After the pyrolytic process any debris
(e.g, ash), can easily be wiped away.
Remember to wait until the oven has
cooled down before doing so!
Danger of burning.
Try not to wipe the fibre-glass seal
when cleaning the oven cavity. It is
particularly sensitive and should not
be cleaned unless absolutely
necessary. Rubbing it can damage
it.
Most residues are easily wiped away
with a damp cloth.
Depending on soiling levels in the oven
there may be visible deposits on the
door and below the trim under the oven
cavity. This is best removed using a
non-abrasive sponge or non-abrasive
stainless steel spiral pad and a mild
solution of warm water and washing-up
liquid.
Deposits on the internal door panel can
be removed using a suitable glass
scraper.
Spilt fruit juices may cause lasting
discolouration to the surfaces. This
discolouration is permanent but will
not affect the efficiency of the
enamel. Do not attempt to remove
these marks.
40
The pyrolytic process will be
cancelled,
– if the soiling levels in the oven are too
much for the programme to deal
with.
The message "Fault - 23" will appear
in the display.
Remove all coarse soiling before
starting the pyrolytic process again.
– if the oven is switched off.
– in the event of a power cut.
Switch the appliance off. If the oven
interior temperature is below 280 °C,
the door lock will be released after a
period of approx. 30 seconds. It can
then be opened.
Start the pyrolytic cleaning process
again if necessary.
Hide quick links:
Advertisement
Table of Contents
