3D Eyewear set (2)
●
TY-EW3D10E
3D Eyewear
Nose pad A
●
Use either nose pad A or B for your preference.
●
3D Eyewear can be worn over vision correction glasses.
■
Part names and functions
Battery cover
●
When using for the first time, remove the insulating sheet.
●
To replace the battery
Infrared receiver
Receives infrared signals from the TV.
●
3D Eyewear is controlled by receiving infrared signals from the TV,
which allows you to view 3D images.
Note
●
Do not soil the infrared receiver section or attach stickers etc. to it.
Lenses - Liquid Crystal Shutter
Controls the images for 3D viewing.
●
The left and right liquid crystal
shutters are alternately opened and
closed in time with the images on the
TV screen to achieve the 3D effect.
Note
●
Do not apply pressure to or scratch
the surface of the liquid crystal
shutter.
3D Eyewear
Specialised band
Nose pad B
Pull the insulating sheet
Insulating sheet
"Replacing the battery" (p. 28)
Nose pad installation section
If required, attach the nose pad.
●
To attach the nose pad
Power button of the 3D Eyewear
(bottom side of the 3D Eyewear)
Switches the 3D Eyewear on or off.
●
Press the button for about 1 second to turn the power on. The
indicator lamp lights for about 2 seconds and then goes off.
●
To turn the power off, press the button for about 1 second again.
The indicator lamp flashes 3 times, then the 3D Eyewear turns
off.
Note
●
If the 3D Eyewear does not receive any signals from the TV for
about 5 minutes, the 3D Eyewear will be turned off automatically.
3D Eyewear case
"Attaching the nose pad" (p. 28)
Specialised band attaching parts
If required, attach the specialised band.
●
To attach the band
"Attaching the specialised band" (p. 28)
Power button
Indicator lamp
27