Remote Control Preparation - Panasonic SC-ZT2 Operating Instructions Manual

Remote control preparation

Inserting the batteries
Press on the tab to open.
Insert so the poles (( and )) match those in the
remote control.
Use manganese batteries or alkaline batteries.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by
the manufacturer. Dispose of used batteries according to the manufacturer's instructions.
Using the remote control
Main unit
8
VQT2R71
(R6/LR6, AA)
Remote control signal sensor
Within approx. 7 meters
at the front (The
Approx. Approx.
30º 30º
remote controlling
range varies according
to the angles.)
Transmission
window
• Do not mix old and new batteries.
• Do not use different types of batteries at the same time.
• Do not take apart or short circuit.
• Do not attempt to recharge alkaline or manganese batteries.
• Do not use batteries if the covering has been peeled off.
• Do not heat or expose to fl ame.
• Do not leave the batteries in an automobile exposed to direct
sunlight for a long period of time with doors and windows
closed.
Mishandling of batteries can cause electrolyte leakage which
can severely damage the remote control.
Remove the batteries if the remote control is not going to be
used for a long period of time. Store them in a cool, dark place.
Note
• Do not place an object between the signal sensor and
the remote control.
• Do not expose the signal sensor to the direct sunlight or
the strong light of a fl uorescent lamp.
• Keep the transmission window and the system's sensor
free from dust.