For the latest information on applicable models, visit our web site. http://panasonic.net/ Thank you for purchasing a Panasonic product. Before using this product, be sure to read “Safety Precautions” and “Using Precautions” pages 2-5). Before operating this product, please read the instructions carefully, and save this manual for future use.
Charge by connecting the included charging cable to the USB terminal of a Panasonic TV supporting 3D. Charging with other devices may result in battery leakage, heating or rupture. Do not use the included charging cable for uses other than charging ...
Page 3
Always keep the 3D Eyewear in a cool, dry place. Be careful not to trap a finger in the hinge section of the 3D Eyewear. Pay special attention when children are using this product. Viewing 3D Content ...
Page 4
3D Eyewear Use 3D Eyewear should not be used by children younger than 5 - 6 years old, as a guideline. All children must be fully supervised by parents or guardians who must ensure their safety and health throughout the using 3D Eyewear. ...
Using Precautions Do not drop or bend the 3D Eyewear. Do not apply pressure to or scratch the surface of the liquid crystal shutter of the 3D Eyewear. Do not soil the infra-red receiver section or attach stickers etc. to it. ...
Identifying Controls (Shown as TY-EW3D2ME) Infra-red receiver Receives infra-red signals from the television. The liquid crystal shutter open/close timing is controlled by receiving infra-red signals from the television, which provide 3D expression of the images. If the eyewear stops receiving infra-red signal from the television, the power automatically switches off after 5 minutes.
Accessories < > indicates the quantity. 3D Eyewear case ·······················<1> Charging cable ···························<1> Ferrite core ·································<1> Attaching Ferrite Core Be sure to attach the provided ferrite core to the charging cable to reduce interference or electrical noise. 1.
Viewing 3D Images NOTE • Charge the 3D Eyewear before using the first time after purchase or after long periods of disuse. Using the television menu controls, set so that 3D images are shown. 1. (When 3D image signals are being received) press the MENU button on the television remote control.
Charging Charging the 3D Eyewear 1. Turn off the television power, and set the 3D Eyewear power switch to “OFF”. 2. Connect as shown in the diagram, and turn on the television power. • The indicator lamp lights red, and charging starts. •...
Disposal A lithium-ion polymer rechargeable battery is built in to the 3D Eyewear. Please discard according to local regulations. When disposing this product, disassemble properly by following the procedure on the next page, and remove the internal rechargeable battery. Do not disassemble this product except when disposing of it. Danger ...
Page 11
How to remove the battery Disassemble this product after the battery has run out of power. The following figures are intended to explain how to dispose of the product, not for describing how to repair. The product cannot be repaired once it has been disassembled. 1.
Troubleshooting/Q&A Check the followings first. If they do not solve the problem, please contact the place of purchase. Images are not 3D. Are the image settings switched to 3D images? Some 3D image signals are not automatically recognised as 3D images. Set “3D Picture Display”...
Liquid Crystal Shutter Usage temperature range 0 °C - 40 °C (32°F - 104°F) DC 5 V ( supplied by USB terminal of a Charging power supply Panasonic TV) Lithium-ion polymer rechargeable battery DC 3.7 V, 70 mAh Battery Operation time* : Approx.
Page 14
If you wish to discard this product, please contact your local authorities or dealer and ask for the correct method of disposal. Pursuant to the directive 2004/108/EC, article 9(2) Panasonic Testing Centre Panasonic Service Europe, a division of Panasonic Marketing Europe GmbH Winsbergring 15, 22525 Hamburg, F.R. Germany Panasonic Corporation Web Site : http://panasonic.net/...