Table of Contents
Advertisement
Part I
Adjust the key with the TRANSPOSE
Transpose illustration
Each press of the
button raises the key in semitone
steps, and each press of the
in semitone steps (G – C – F ).
If the two buttons are pressed at the same time, the
key returns to C.
Harmony
This function automatically adds harmony to the single-note melody you play in the right part, based on the chord you
specify in the left part.
1.
Press the HARMONY button to turn it on.
HARMONY
The
mark next to the HARMONY indication on the
left side of the display indicates that this effect is on.
The display looks similar to the following.
TOUCH
SUSTAIN
HARMONY
TRANSPOSE
TEMPO
APC
GENERAL
SYNCHRO
If necessary, the TRANSPOSE/PROGRAM buttons
can be used to select the type of harmony.
Perform this operation while the PROGRAM indication
is flashing on the display. After a few seconds, the
display returns to the previous display.
For details about each type, refer to the separate
REFERENCE GUIDE provided.
20
QQTG0598
and
buttons.
SOUND
TOUCH
SUSTAIN
HARMONY
TRANSPOSE
APC
GENERAL
SYNCHRO
When the TRANSPOSE function is active, the trans-
button lowers the key
pose illustration is shown on the display.
When PROGRAM is shown on the display above the
buttons, these buttons are used for various settings
and cannot be used for TRANSPOSE. To access the
TRANSPOSE function in this case, first exit the setting
mode.
2.
During a performance using the automatic accompani-
ment (refer to page 23), while specifying the chord
with your left hand, play the melody with your right
hand.
If the "Octave", "Hard Rock" or "Fanfare" type is
selected, HARMONY is added even when the auto-
matic accompaniment is not used.
CHORD
VOLUME
PROGRAM
Sound and effects
Key
TEMPO
VOLUME
TRANSPOSE
PROGRAM
Hide quick links:
Advertisement
Table of Contents
