Auto Power Standby Function - Panasonic Viera TX-P42GT20B Operating Instructions Manual

TV
CI slot
(p. 62)
USB 1 / 2 ports
1
Function select
2
●
Common Interface
Volume / Contrast / Brightness / Colour / Sharpness /
F
Tint (NTSC signal) / Bass ("Music" or "Speech" mode in the
Sound Menu) / Treble ("Music" or "Speech" mode in the
Sound Menu) / Balance / Auto Setup (p. 44 and p. 45)
TV
Changes the input mode
AV
SD Card slot
(p. 72)
HDMI4 terminal
HDMI 4
Headphones jack
AV 3
V
AV3 terminals
L
R
Mains power On / Off switch
●
Use to switch mains power On / Off.
If the TV was switched off whilst in Standby mode, using the Mains Power On / Off switch,
then it will be in Standby mode when switched back on using the same switch.
Using the On Screen Displays
Many features available on this TV can be accessed via the On Screen Display menu.
■
How to use remote control
MENU
Open the main menu
Move the cursor / select the menu item
Access the menu / store settings after
adjustments have been made or options
have been set
■
ON SCREEN HELP Instructions box - Operation guide
Example (Owner ID):
Owner ID
Please enter new PIN
PIN *
EXIT
PIN entry
0 9
RETURN
■

Auto power standby function

●
The TV will automatically go to Standby mode in the following conditions:
• no signal is received and no operation is performed for 30 minutes in Analogue TV mode
• "Off Timer" is active in the Setup Menu (p. 19)
• no operation is performed for the period selected in "Auto Standby" (p. 40)
●
This function does not affect the recording of Timer Programming, Direct TV Recording and One Touch
Recording.
Infrared transmitter for 3D Eyewear
●
Do not place any objects between the
transmitter and 3D Eyewear.
(p. 13, 68, 72 and p. 81)
For changing TV channel up or down.
When a function is selected by the F button, press to increase or
decrease the setting of the selected function.
When in Standby mode, press either button for about 1 second to
switch the TV On.
(p. 99)
(p. 99)
(p. 99)
* * *
Operation guide will help you.
Remote control signal receiver
●
Do not place any objects between the TV remote control signal
receiver and remote control.
C.A.T.S. (Contrast Automatic Tracking System) sensor
●
Senses brightness to adjust picture quality when "C.A.T.S."
in the Picture Menu is set to "On" (p. 36)
Power and Timer LED
●
Red : Standby
Green: On
Orange: Timer Programming On
Orange (flash): Recording of Timer Programming,
Red with
orange flash: Standby with Timer Programming
●
The LED blinks when the TV receives a command
from the remote control.
Adjusting the panel to your desired angle
●
Do not place any objects within the full rotation range.
15º
EXIT
Exit the menu system and return to the
normal viewing screen
Move the cursor / adjust levels / select from
a range of options
BACK/
RETURN
Return to the previous menu
Direct TV Recording or
One Touch Recording
is in progress
On, Direct TV Recording or
One Touch Recording
(View from the top)
15º
9