Wireless Remote Controller (Optional) - LG Air Conditioner Owner's Manual

Product Introduction

Wireless Remote Controller (Optional)

This air-conditioner is equipped with wired remote controller basically. But if you want to be available with
wireless remote controller, you pay for it.
5
6
4
2
7
ON OFF
11
8
13
14
CAUTION:
• Aim at the signal receiver on the wired remote controller so as to operate.
• The remote control signal can be received at a distance of up to about 7m.
• Be sure that there are no obstructions between the remote controller and the signal receptor.
• Do not drop or throw the remote controller.
• Do not place the remote controller in a location exposed to direct sunlight, or near the heating unit, or
any other heat source.
• Block a strong light over the signal receptor with a curtain or etc. so as to prevent the abnormal
operation. (ex:electronic quick start, ELBA, inverter type fluorescent lamp)
NOTE
❈ The wireless remote controller do not operate the vane angle control.(4Way Type)
❈ For more details refer to the Wireless Remote Control Accessory manual.
❈ The actual product can be different from above contents depending upon model type.
8 Ceiling Cassette-Type Air Conditioner
1. ON/OFF BUTTON
Signal transmitter
2. OPERATION MODE SELECTION BUTTON
3. ROOM TEMPERATURE SETTING BUTTONS
4. INDOOR FAN SPEED SELECTOR
5. JET COOL BUTTON
1
6. CHAOS SWING BUTTON
3
7. ON/OFF TIMER BUTTONS
10
CANCEL
8. TIME SETTING BUTTONS
9
SET
AUTO CLEAN
9. TIMER SET/CANCEL BUTTON
12
10. SLEEP MODE AUTO BUTTON
15 11. AIR CIRCULATION BUTTON
12. ROOM TEMPERATURE CHECKING BUTTON
13. PLASMA
Flip-up door
(opened)
14. RESET BUTTON
15. 2nd F Button
of handling the Remote Controller
Used to Turn off/on the unit.
Used to select the operation mode.
Used to select the room temperature.
Used to select fan speed in four steps
low, medium, high and CHAOS.
Used to start or stop the speed cooling.
(Speed cooling operates super high fan speed.)
Used to stop or start louver movement and set the desired up/down
airflow direction.
Used to set the time of starting and stopping operation.
Used to adjust the time.
Used to set and to cancel the Timer operation.
Used to set Sleep Mode Auto operation.
Used to circulate the room air without cooling or heating.
Used to check the room temperature.
Used to start or stop the plasma-purification function.
Initialize remote controller.
Used prior to using modes printed in blue at the bottom of buttons.