Communicating With The Dolphin Terminal - Hand Held Products Hand Held Computer Dolphin 7450 User Manual

To configure the Dolphin 7400/7450 terminal for communications, see the previous section on Configuring the Dolphin
Terminal.

Communicating with the Dolphin Terminal

To communicate with the Dolphin and any other devices connected to the Dolphin Charging/Communication cradle:
1. Insert the Dolphin into the terminal well of the HomeBase/IntelliBase/USB HomeBase. If the Dolphin is in sleep mode, it will
awaken into active state.
2. The DOCK LED on the cradle will illuminate. If the Dolphin does not turn on, or the LED does not light up, make sure that it
is properly seated in the terminal well and that the power supply is properly connected to the cradle and plugged into a
functioning AC outlet.
3. Start your application on the Dolphin terminal or the host computer. Data can then begin transmitting between the terminal
and the devices connected to the Dolphin cradle.
When data transfer begins, the COMM LED on the cradle will blink red and green. If the HomeBase/IntelliBase/HomeBase will
not communicate with the Dolphin, check the port connections to ensure that the cradle is correctly configured.
6 - 14
ActiveSync Connection Settings