Volvo V70 Owner's Manual page 254

06 Infotainment system
Radio
Regional radio programmes – REG
This function causes the radio to continue with
a regional transmitter even if its signal strength
REG
is low. The symbol
tion is active.
–
Activate/deactivate in FM mode under
menu Advanced settings
Resetting RDS functions
All radio settings can be reset to the original
factory settings.
–
The reset is carried out in FM mode under
FM menu Advanced settings
Reset all FM settings.
Volume control, programme types
The interrupting programme types, e.g.
NEWS or TP , are heard at the volume selected
for each respective programme type. If the vol-
06
ume level is adjusted during the programme
interruption, the new level is saved until the
next programme interruption.
Scan wavelength
The function automatically searches for avail-
able channels and takes into account any pro-
gramme type filtering. When a station is found,
it is played for approx. 10 seconds before
scanning is resumed. When a station is playing
back it can be saved as a preset in the usual
way, see the section Preset, page 249.
*
252
Option/accessory, for more information, see Introduction.
–
To start scanning go in FM/AM mode to
FM menu
shows that the func-
Scanning stops if a station is saved.
FM
REG.
Radio system - DAB*
General
DAB (Digital Audio Broadcasting) is a digital
broadcasting system for radio. This system
supports DAB, DAB+ and DMB.
Coverage for DAB is not available in all loca-
tions. If there is no coverage then the mes-
sage
screen.
Service and Ensemble
•
Service - Channel, radio channel (only
audio services are supported by the sys-
tem).
•
Ensemble - A collection of radio channels
on the same frequency.
Storing channel groups (Ensemble learn)
When the vehicle is moved to a new broad-
casting area, programming of existing channel
groups in the area may be necessary.
Scan or AM menu
NOTE
NOTE
No reception
is shown in the display
Programming of channel groups creates an
updated list of all available channel groups.
Scan.
The list is not updated automatically.
Programming is carried out in the menu system
in DAB mode under
learn. Programming can also take place as fol-
lows:
1. Turn TUNE one step in either direction.
> Ensemble learn
available channel groups.
2. Press OK/MENU.
> New programming is started.
Programming can be cancelled with EXIT.
Navigation in channel group list
(Ensemble)
To navigate in and access the channel group
list turn TUNE. The name of the Ensemble is
shown in the upper part of the TV screen. When
switching to the new Ensemble the name
changes to the new one.
•
Service - Shows channels irrespective of
the channel group to which they are allo-
cated. The list can also be filtered using the
selection of programme type (
filtering ), see below.
DAB menu Ensemble
is shown in the list of
PTY