Volvo V70 Owner's Manual page 163

braking. The driver must then re-activate the
cruise control in one of the following ways:
•
Press the steering wheel button
or
•
Depress the accelerator pedal.
> The cruise control will then resume follow-
ing the vehicle in front.
NOTE
Queue Assist can hold the car stationary for
a maximum of 4 minutes - then the parking
brake is applied and Cruise Control is dis-
engaged.
•
The driver has to release the parking
brake before the cruise control can be
reactivated.
Change of target
.
If the target vehicle in front suddenly turns then
there may be stationary traffic in front.
When the cruise control is following another
vehicle at speeds below 30 km/h and changes
target from a moving to a stationary vehicle, the
cruise control will slow down for the stationary
vehicle.
WARNING
When the cruise control is following another
vehicle at speeds in excess of 30 km/h and
the target is changed from a moving vehicle
to a stationary vehicle, the cruise control will
ignore the stationary vehicle and instead
select the stored speed.
•
The driver must intervene him/herself
and brake.
04 Driver support
Adaptive cruise control*
Automatic standby mode with change of
target
Cruise control is disengaged and set in
standby mode:
•
when the speed is below 5 km/h and cruise
control is not sure whether the target
object is a stationary vehicle or some other
object, e.g. a speed bump.
•
when the speed is below 5 km/h and the
vehicle in front turns off so the cruise con-
trol no longer has a vehicle to follow.
Termination of automatic braking at a
standstill
In certain situations Queue Assist automati-
cally interrupts braking when stationary. This
means that the brakes are released and the car
may start to roll - the driver must therefore
intervene and brake the car himself/herself in
order to maintain its position.
Queue Assist releases the foot brake and sets
cruise control in standby mode in the following
situations:
•
the driver puts his/her foot on the brake
pedal
•
the parking brake is applied
•
the gear selector is moved to P, N or R
position
•
the driver sets the cruise control in standby
mode.
*
Option/accessory, for more information, see Introduction.
04
161