Transport And Storage - Husqvarna K 970 Rescue Operator's Manual

Pipe cutting and pinching
Special care should be taken whet cutting in pipes. If the pipe
is not properly supported and the cut kept open through out
the cut the blade might be pinched in the kickback zone and
cause a severe kickback.
How to aviod kickback
Avoiding kickback is simple.
• The work piece must always be supported so that the cut
stays open when cutting through. When the cut opens
there is no kickback. If the cut closes and pinches the
blade ther is always a risk of kickback.
• Take care when inserting the blade in an existing cut.
• Be alert to movement of the work piece or anything else
that can occur, which could cause the cut to close and
pinch the blade.

Transport and storage

• Secure the equipment during transportation in order to
avoid transport damage and accidents.
• For transport and storage of cutting blades, see the
section "Cutting blades".
• For transport and storage of fuel, see the section "Fuel
handling".
• Store the equipment in a lockable area so that it is out of
reach of children and unauthorized persons.
16 –
English
OPERATING