Drive; Transport And Storage - Husqvarna K6500 Ring Operator's Manual

Drive

On account of the machine's unique design the driving
power is not transferred at the centre of the blade. The
flanges on the two guide rollers run in the blade's groove.
Springs on the guide rollers press out the rollers, which in
turn press the V-shaped edge on the inside diameter of
the blade against the V-shaped groove in the drive wheel.
The drive wheel is fitted on an axle which is driven by the
engine via a drive belt.
This allows a total cutting depth of 270 mm (10,6 inches)
with a 350 mm (14 inches) diamond blade.
1
5
4
1 Blade
2 Support rollers
3 Drive wheel
4 Guide rollers
5 V-shaped edge
NOTICE! The roller setting should be checked twice
during the life of the diamond blade, once after fitting the
blade and when the blade is semi worn.
BLADES
2
3

Transport and storage

• Make sure the machine is secured and that the blade
are properly protected during the transport and
storage of the machine.
• Before use inspect blade for transport or storage
damage.
• Store the blade in a dry place.
–
English 9