Panasonic TX-L42DT50Y Operating Instruction page 110

Problem
Cannot connect to the
network
Cannot select the file
during DLNA operations
Cannot operate
VIERA Connect
The TV does not switch on
The TV goes into Standby
mode
The remote control does
not work or is intermittent
Parts of the TV become
hot
The LCD panel moves
slightly when it is pushed
with a finger
Clattered sound might be
heard
[Faulty dish] message
appears
Overcurrent error
message appears
An error message appears
110
Check the LAN cable or wireless LAN is connected properly.
Check the connections and settings.
Check the network equipment and network environment.
The router may not be set to issue IP address automatically. If the network
administrator prefers to allocate an IP address, set an IP address manually.
(p. 82)
The router may be using MAC address filtering (security setting).
Confirm the MAC Address of this TV (p. 42) and set the router to use it.
If the problem persists, consult your Internet Service Provider or
telecommunications company.
Is media server of the connected equipment prepared?
Check applicable data format.
Check the connections and settings.
The server or connected line may be busy now.
Check the mains lead is plugged into the TV and the socket outlet.
Auto power standby function is activated.
The TV enters Standby mode about 30 minutes after analogue broadcasting
ends.
Are the batteries installed correctly?
Has the TV been switched on?
The batteries may be running low. Replace them.
Point the remote control directly at the TV's remote control signal receiver
(within about 7 m and a 30 degree angle of the signal receiver).
Situate the TV away from sunshine or other sources of bright light not to shine
on the TV's remote control signal receiver.
Even when the temperature of parts of the front, top and rear panels has risen,
these temperature rises do not cause any problems in terms of performance or
quality.
There is some flexibility around the panel to prevent damage to the panel.
The panel might move slightly when it is pushed with a finger, and clattered
sound might be heard. This is not a malfunction.
The satellite cable might be short-circuited or there might be connection
problems of the cable. Check the cable and connection and then turn the TV off
with the Mains power On / Off switch, and turn it on again.
If the message still persists, consult a dish installer for checking the dish and
cable.
The connected USB device might cause this error. Remove the device and turn
the TV off with Mains power On / Off switch, then turn it on again.
Check foreign objects are not inside the USB port.
Follow the message's instructions.
If the problem persists, contact your local Panasonic dealer or the authorised
service centre.
Causes / Actions
(p. 80 - 84)
(p. 101, 102)
(p. 80 - 84)
(p. 11)
(p. 7)
(p. 80)
(p. 79)