Preparing The Remote Control; Demo Function - Panasonic SC-PM38 Operating Instructions Manual

Simple setup
(continued)
Optional antenna connections
FM outdoor antenna
FM outdoor antenna (not included)
75 Ω coaxial cable
(not included)
• Never use an outdoor antenna during a lightning storm.
• You can connect the FM outdoor antenna for better reception. Please consult your dealer for installation.
• Disconnect the FM indoor antenna if an FM outdoor antenna is installed.
• Connect the AM outdoor antenna without removing the AM loop antenna. Run 5 to 12 m of vinyl-covered wire horizontally along a window or other
convenient location.

Preparing the remote control

Batteries

• Use a manganese dry battery or an alkali dry battery.
• Insert so the poles (+ and –) match those in the remote control.
• Remove if the remote control is not going to be used for a long period
of time.
• Store in a cool, dark place.
• Do not heat or expose to flame.
• Do not leave the batteries in an automobile exposed to direct sunlight
for a long period of time with doors and windows closed.
• Mishandling of batteries in the remote control can cause electrolyte
leakage, which may cause a fire.
Use

Aim at the remote control sensor, avoiding obstacles, at a maximum
range of 7 m directly in front of the unit.
Refer to page 6 for remote control signal sensor position.

DEMO function

iPod USB
FM/AM
/ /
[g, –DEMO]
DEMO
VOLUME VOLUME
CD
/
_
+
OPEN/CLOSE
AM outdoor antenna
AM outdoor antenna
(not included)
5 to12 m
Place this side in before the other side
Do not:
• mix old and new batteries;
• use different types of batteries at the same time;
• take apart or short-circuit;
• attempt to recharge alkaline or manganese batteries;
• use batteries if their covering has been peeled off.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace
only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the
manufacturer's instructions.
When the unit is first plugged in, a demonstration of its functions may be
shown on the display.
If the demo setting is off, you can show a demonstration by selecting
"DEMO ON".
Press and hold [g, –DEMO].
The display changes each time the button is held down.
DEMO OFF
While in standby mode, select "DEMO OFF" to reduce power
consumption.
AM loop antenna
(included)
R6/LR6, AA
DEMO ON
5 5