Turning On/Off The Power; Switching Between Operate On/Off With The Button On The Front Panel; Switching Between Operate On/Off With The Signal I/O Terminal - JVC VR-509E Instructions Manual

Installation and Preparation

Turning On/Off the Power

Switching the Power On
1. Connect the Power Cable.
• Connect using the power cable supplied to an AC 220 V
- 240 V 50Hz/60Hz outlet.
2. Switch on the power switch on the rear panel.
• The main power is turned on to initiate a system check.
• The OPERATE indicator will blink.
• The OPERATE indicator will then be steadily illuminated,
indicating that the OPERATE ON mode has been
activated. Operations are possible when the on-screen
display (REC/STOP mark, date and time) appears on the
VIDEO OUT.
CAUTION
Do not disconnect the power cable when the system
check is being run under any circumstances. Failure to
observe this may result in malfunctions.
Switching the Power Off
1. Press the [OPERATE] button for at least two
consecutive seconds to move across to the OPERATE
OFF mode.
• The OPERATE indicator will be extinguished after a
while.
2. Switch off the power switch on the rear panel.
MEMO
It is recommended that a UPS (Uninterruptible Power
Supply) is used in consideration of power failures, etc.
(See System Connection on page 15)
(See Connecting a UPS on page 64)
CAUTION
Do not move the VR-509 for at least one minute after the
power has been switched off. Failure to observe this may
result in damage to the internal disk drive if it is subject to
shock at this time.
16
Switching between OPERATE ON/OFF
with the button on the front panel
It is possible to switch between the operational mode
(OPERATE ON) and the stand-by mode (OPERATE OFF).
OPERATE ON
Press the [OPERATE] (when in the OPERATE OFF mode)
button.
• The OPERATE indicator will blink.
• The OPERATE indicator will then be steadily illuminated,
indicating that the OPERATE ON mode has been
activated. Operations are possible when the date and
time appears on the on-screen menu.
* The OPERATE ON mode will be started up automatically
when the power switch on the rear panel is switched on.
OPERATE OFF
Press the [OPERATE] button for at least two seconds
(when in the OPERATE ON mode).
• The OPERATE indicator will blink.
• A message stating "Please wait..." will be displayed.
• The OPERATE OFF mode will then be activated, and the
OPERATE indicator will be extinguished.
* Activate the OPERATE OFF mode before switching off
the power.
* Switch off the power supply to the VR-509 before
switching off the external hard disk drive.
Switching between OPERATE ON/OFF
with the signal I/O terminal
OPERATE ON
Set the OPERATE ON/OFF terminal to Low (0V) (when in
the OPERATE OFF mode).
• A system check will be started.
• The OPERATE ON mode will then be activated.
Operations are possible when the on-screen display
(REC/STOP mark, date and time) appears on the VIDEO
OUT.
OPERATE OFF
Set the OPERATE ON/OFF terminal to Low (0V) (when
in the OPERATE ON mode).
• A message stating "Please wait..." will be displayed.
• The OPERATE OFF mode will then be activated, and the
OPERATE indicator will be extinguished.
* Activate the OPERATE OFF mode before switching off
the power.
* This will not function during emergency recording or when
the scan-disk function is in progress.