Meridian DSP8000 User Manual page 17

To connect to a Meridian product using SpeakerLink (daisy chain)
Front R – Slave
MERIDIAN
SPEAKERLINK
INPUT OUTPUT
SpeakerLink lead
You can create a complete system by connecting a pair
of DSP8000 loudspeakers directly to a digital source.
The DSP loudspeakers include volume, balance, and
tone controls allowing you to control the system using
an MSR+.
If the Meridian source or control unit includes a
Meridian SpeakerLink output, such as the Meridian
808.3 CD Player, you can make all the connections
using SpeakerLink leads. The Meridian SpeakerLink
connection provides both two-channel digital audio and
Meridian Comms control.
This is an alternative to the "home run" wiring
configuration shown in the previous section.
• Connect the upper SpeakerLink output from the
Meridian product to the SpeakerLink input on
the DSP8000 chosen as the master, using a
SpeakerLink lead.
• Connect the SpeakerLink output from the master
DSP8000 to the SpeakerLink input on the other
(slave) DSP8000, using a second SpeakerLink lead.
Meridian 808.3 CD Player
MERIDIAN
SPEAKERLINK
Configure the master DSP8000 as M.RJ45 and the
•
slave DSP8000 as S.RJ45; see To choose master or
slave and the primary connector , page 24.
Front L – Master
MERIDIAN
SPEAKERLINK
INPUT OUTPUT
SpeakerLink lead
13
Setting up
the DSP8000
loudspeakers