Connecting To Other Equipment - Meridian DSP8000 User Manual

12
Setting up

Connecting to other equipment

the DSP8000
loudspeakers
To connect to a Meridian product with SpeakerLink (home run)
Front R – Slave
MERIDIAN
SPEAKERLINK
INPUT OUTPUT
You can create a complete system by connecting a pair
of DSP8000 loudspeakers directly to a digital source.
The DSP loudspeakers include volume, balance, and
tone controls allowing you to control the system using
an MSR+.
If the Meridian source or control unit includes a
Meridian SpeakerLink output, such as the Meridian
808.3 CD Player, you can make all the connections
using SpeakerLink leads. The Meridian SpeakerLink
connection provides both two-channel digital audio and
Meridian Comms control.
This is an alternative to the "daisy chain" wiring
configuration shown in the next section.
• Connect the upper SpeakerLink output from the
Meridian product to the SpeakerLink input on
the DSP8000 chosen as the master, using a
SpeakerLink lead.
• Connect the lower SpeakerLink output from the
Meridian product to the SpeakerLink input on the
other (slave) DSP8000, using a second SpeakerLink
lead.
Meridian 808.3 CD Player
SpeakerLink lead
MERIDIAN
SPEAKERLINK
SpeakerLink lead
• Configure the master DSP8000 as M.RJ45 and the
slave DSP8000 as S.RJ45; see To choose master or
slave and the primary connector , page 24.
Front L – Master
MERIDIAN
SPEAKERLINK
INPUT OUTPUT