Table of Contents
Advertisement
E,
ANTI-TIP
DEVICE
INSTALLATION
INSTRUCTIONS
NOTE: A risk of range tip over exist if the appliance is
not installed in accordance with the installation instruc-
tions provided. The proper use of this device minimizes
the risk of TIP-OVER.
in using this device the consumer
must still observe the safety precautions as stated in the
USE and CARE MANUAL and avoid using the oven
door and/or lower drawer as a step stool.
Installation instructions are provided for wood and ce-
ment in either floor or wall. Any other type of construc-
tion may require special installation
techniques
as
deemed necessary to provide adequate fastening of the
ANTI-TIP
bracket to the floor or walt.
STEP 1 - Locating The Bracket
A. Mark the floor or wall where either the right or left
"EDGE" of the 30" opening is to be located.
B. Place the BRACKET SIDE, see figure 1, at the
marked "EDGE" and against the back wall.
C. Use the bracket as a template and mark the re-
quired holes, as shown in figure 1, for the type of
construction you wilt be using.
STEP 2 - Anti-Tip Bracket Installation
A. Wood Construction:
Floor: Locate the center of the two holes identi-
fied in figure 1 as "FLOOR-WOOD".
Drill a 1/8"
pilot hole in the center of each hole (a nail or awl
may be used if a drill is not available). Secure
the ANTI-TIP
bracket to the floor with the two
screws provided. Proceed to STEP 3.
2_
Wall: Locate the center of the two holes identi-
fied in figure 1 as "WALL-PLATE".
Drill an an-
gled 1/8"piIot hole in the center of each hole as
shown in figure 2. (A nail orawl may be used if a
drill is not available).
Secure the ANTI-TIP
bracket to the wall with the two screws provided
as shown in figure 2. Proceed to STEP 3.
B. Cement or Concrete Construction:
.
Suitable screws for concrete construction
can
be obtained at the hardware store. Drill the re-
quired size hole for the hardware obtained into
the concrete at the center of the holes identified
in figure 1 as "FLOOR--CEMENT".
Secure the
ANTI-TIP
bracket
to the floor.
Proceed
to
STEP 3.
STEP 3 - Range Installation
A. Complete the installation of the range per the instal-
lation instructions provided with the product.
B,
Align the range to its designated location and slide it
back into position. Note: A minimum clearance of
1/4" is required between the range and the leveling
foot that will engage the ANTI-TIP bracket, see fig-
ure 2.
C.
For SAFETY CONSIDERATIONS
as welt as opti-
mum performance adjust the range so that it is level.
This may be checked by placing a spirit level or a
large pan of water on the cooktop or the oven rack. If
an adjustment is required pull the range forward, tip
the range and rotate the leveling feet as required.
O.
To check the range for proper installation of the
anti-tip bracket: Use a flashlight and look under-
neath the bottom of the range to see that one of the
rear leveling legs is engaged in the bracket slot.
E. Proceed with the remainder of the installation in-
structions provided with the range.
--._
(uooo
_
_
_='_
FIGURE 1
1
,_,. ,=,,-7,, FIGURE 2
-3-
Hide quick links:
Advertisement
Table of Contents
