Table of Contents
Advertisement
iNSTALLATiON
Too(s and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
Tools needed:
Flat-blade screwdriver
#2 Phillips screwdriver
Wire stripper
(direct wire installations)
1/4" nut driver
(recommended)
Tin snips
(new vent installations)
@
Vent clamps
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Utility knife
Tape measure
Level
Pliers
G
Caulking gun and
compound
(for installing
new exhaust vent)
REQUIREMENTS
Parts supplied:
Leveling legs (4)
Parts package is located in dryer drum. Check that all parts
are included.
Parts needed:
Check local codes. Check existing electrical supply and venting,
and read "Electrical Requirements"
and "Venting Requirements"
before purchasing parts.
Mobile home installations require metal exhaust system
hardware, available for purchase from the dealer from whom
you purchased your dryer. For further information,
please
reference the "Assistance
or Service" section of the Dryer
User instructions.
If using a power supply cord:
Use a UL listed power supply cord kit marked for use with
clothes dryers. The kit should contain:
[]
A UL listed 30-amp power supply cord, rated 120/240 volt
minimum. The cord should be type SRD or SRDT and be
at least 4 ft. (1.22 m) long. The wires that connect to the
dryer must end in ring terminals or spade terminals with
upturned ends.
[]
A UL listed strain relief.
Location Requirements
Explosion Hazard
Keep flammable
materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (460 ram) above the floor
for a garage installation.
Failure to do so can result in death, explosion,
or fire.
You will need:
[]
A location allowing for proper exhaust installation.
See "Venting Requirements."
[]
A separate 30 amp circuit.
Hide quick links:
Advertisement
Table of Contents
