Installation Requirements; Tools And Parts - Maytag MDB8959SBS2 Installation Instructions Manual

INSTALLATION REQUIREMENTS
Gather the recommended tools and parts before starting
installation. Read and follow the instructions provided with any
tools listed here.
All Installations
Tools needed:
P ors Flat-blade
• screwdriver
5/_6"and 1/4" _ _tedlCSA --
nut drivers or _._ Approved twist-on _
hex sockets _ wire connectors*
10 adjustab e wrench %" n n
." " h _ ope -e d
that opens to _JJ_"-" wrn^h ._/CJ"
1 _ L, 1V=' (2 9 cm) _,
*Must be the proper size to connect your household winng
to 16-gauge wiring in dishwasher.
Other useful items you may need:
Shallow Bath
pa towel -_J" !
Parts supplied:
Drain hose
clamps (2)
(1 large and
1 small)
Drain
hose
#10 x W' Undercounter
PhiSps-head mounting
screws (2) brackets (2)
Make sure all these parts are included in the literature package.
t®TORX and T20 are registered trademarks of Saturn Fasteners, Inc.
Parts needed:
3A Comprx 3A hose fltt!ng
For part or kit, see local
retailer or call Whirlpool
Parts: 1,800-442-9991. Pa rt
Number W10273460
Other parts you may also need:
I !I/='L2 ' I Masking or
Moisture
(3,8!-5 cm} I duct tape bardertape f_/_!
Sc[ew:type .... I I(Part Number Jj/ I
damps (3 maximum) 4396277) _!
NOTE: Parts available for purchase in plumbing supply stores.
Check local codes. Check existing electrical supply. See
"Electrical Requirements" section. It is recommended that
electrical connections be made by a licensed electrical installer.
In addition, for first-time installations
Tools needed:
IW ith 1/2 -[;L
land 1W' hole _) Small
I Saw bits _ tubing Cutter wire stripper I
Parts needed:
Copper tubi!g
(3/8"
see "EleCtrical Requirements" section,
O.D.suggested)0r i .. : i .. .. ,
flexible braidecl For uirectwire: For _-ower buppw
w I lin use UL Listed/ Cord" use UL
ater supp y e
CSA Approved Listed/CSA
I strain relef I Approved power
(,ttLkk£._ _)j_).)));) I to fit %, (2.2 Cm) Supply c0rd kit
hole marked for use with
diShWasher